Audiovox VBT100 owner manual TV Tuner Parts, Unfolding Support BAR, Connecting Power

(Improper handling may result in in injury.)

!Every connection should be tight and in the right direction for the best results.

!Dont' watch TV while driving.

!Avoid direct heat or moisture when installing this unit.

!To avoid an electric shock potential, do not attempt to service. Contact your local service agency.

!Use the supplied AC adapter or car DC adapter.

!Install on the flat surface and unfold support bar.

TV TUNER PARTS

CHANNEL UP AND DOWN

A/V OUT

UNFOLDING SUPPORT BAR

1. Before using the tuner, rotate the support bar clockwise. Make certain the unit is stable before extending and rotating the antenna rods.

CONNECTING POWER

1. Connect the TV tuner to a monitor by

connecting cord to A/V out jack( ).

2. Connect to power source using AC adapter or car DC adapter (12V)( ).

3. Pull out the antenna rod( ) then rotate the rod to find the best reception.

1. The "QUICK MEMORY" and "AUTO MEMORY"

function is a convenient function which allows you

to automatically tune in the available channels with

just one button.

2. To enable the QUICK MEMORY function, push menu button( ) for 3~4 seconds. "QUICK MEMORY" will be displayed on the screen. It will

take about 20 seconds to scan all channels.

3.Generally the quick memory function finds most of the available channels but sometimes you need the "AUTO MEMORY" function for weaker channels. To enable the

"AUTO MEMORY" function, push channel up/down buttons( ) for 3~4 seconds. "AUTO MEMORY" will appear on the screen. Channel scanning will take approximately 30~40 seconds.

1.To add the channel manually, push menu button( ) two times, then "SKIP MODE-ON" will appear on the screen. Push the channel up or down button( ) to change skip mode

from "ON" to "OFF". Push menu button(	) to exit menu. Select desired channels one
by one with channel up or down button(	). When you push the menu button( ), if the

channel is not a memorized one, "ADD CH-NO" will appear, otherwise "ERASE CH-NO" will appear.Then push channel up or down button( ) to add or erase the channel manually.Then push the menu button( ) again then up or down button( ) to set skip mode "ON".Then press the munu button( ). When you finished, push channel up or down button( ) to check the memorized channels.