Setting the Clock / Error Codes

Indicates disc lever error. Press eject button.

Indicates disc reading error. Eject the disc, make sure

it is clean, undamaged, and loaded correctly (label side up). Re-load the disc and check for proper operation or try another disc.

SETTING THE CLOCK

1.Switch the vehicle ignition “on” and the radio “on” (radio frequency or disc track number will be shown on the display panel).

2.Press and hold the time button (T/F) approximately 2 seconds

until the time display appears with AM or PM and the colon ( : ) flashing. Release the T/F button.

3. Press the Down Tuning button ( ) to adjust the hours and the AM/PM indication, and the Up Tuning button ( ) to adjust the minutes to the correct time.

4.When the correct time is shown on the display panel, wait 5 seconds for the display to return to the normal indication.

ERROR CODES

If a problem should develop while operating the CD player, the following error codes may be displayed on the display panel:

INF-1: Indicates mechanical malfunction. Press the Reset button dn.

INF-2: Indicates mechanical malfunction. Press the Reset button dn.

INF-3: Indicates mechanical malfunction. Press the Reset button dn.

INF-4: Indicates disc focus error. Press the Reset button dn.

INF-5: Indicates disc focus error. Press the Reset button dn.

INF-6: Indicates mechanical malfunction. Press the Reset button dn.

INF-7: Indicates data error. Press the Reset button dn. INF-8:

INF-9:

If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.