Audiovox ACC-60 manual Operating

INSTRUCTIONS

1 3,4,5,6,7,8 17 31 13,14,15 16,32 28,29 10,18,19 33

OPERATING

2

9

PWR	SEL
	LOUD
		CDC
	VOLUME	5 DISC DISC

+ SEL

ACC-60

BAND

MO/AUX

1SCN

		1		REL	11
		4x40 WATTS
			2
		5	3 TUNE	AS/PS
			TRK
			4
2 RPT	3	4RDM 5PGM	6MEMCLR	T/FCLK

30

2627 20 21 22 23 25 24

12

6

1POWER (PWR) BUTTON

Press this button to turn the unit on and off. When the ignition switch is on, the radio will turn on automatically when the CDC, BAND or AUX button is pressed.

2VOLUME CONTROL

To increase the volume level, rotate the VOLUME control in the clockwise direction. The volume will increase and the level will be shown on the display panel from a minimum of V -0to a maximum of V -46To decrease the volume level, rotate the con- trol in the counterclockwise direction. The display will automatically return to the nor- mal indication 5 seconds after the last vol- ume adjustment or when another function is activated. This control is also used in conjunction with the SEL/LOUD button to adjust the bass, treble, balance and fader levels as described in 4 5 6 7.

3SELECT (SEL)/LOUD BUTTON

This button is used to select the audio function (volume, bass, treble, balance or fade) to be adjusted using the VOLUME

control. Pressing the Select button once will set the unit for volume adjustment (VOL will mo- mentarily appear on the display panel, followed a few seconds later by V --and the setting num- ber). Pressing the button additional times will select bass adjustment (BAS on display panel), treble adjustment (TRE), balance (BAL), fader (FAD), and volume (VOL) again. The display will return to the normal indication 5 seconds after the last adjustment or when another function is activated. Refer to paragraph 8 for the LOUD function of this button.

4BASS CONTROL

To adjust the bass level, first select the Bass mode by pressing the SEL/LOUD button until the BAS indication appears on the display panel. Within 5 seconds of choosing the Bass mode, rotate the VOLUME Control to adjust the bass response as desired. The bass level will be shown on the display panel from a minimum of B -6to a maximum of B +6 (B 0 represents flat response). The display will automatically return to the normal indication 5 seconds after the last adjustment or when another function is activated.