Auto Page RS-622 manual To Remote Start the Vehicle, Safety Start Operation

Page 6

REMOTE START OPERATION:

WARNINGS:

As with any product that performs automatic functions, there are certain safety precautions that you must practice and be aware of.

1.Keep the transmitter out of children’s reach.

2.Do not leave anyone in the vehicle while running on remote control.

3.Alert servicing personnel that the vehicle can be started automatically.

4.Do not start the vehicle by remote while it’s in an enclosed area or garage.

5.Always apply the parking brake and lock the vehicle as you exit the vehicle.

6.Should the unit malfunction, disconnect the fuse until the problem is corrected.

7.The use and operations of this system is the sole responsibility of the operator.

8.Some areas may have local ordinances that prohibit leaving a vehicle running on public streets.

A. TO REMOTE START THE VEHICLE:

When you want to start your vehicle,

1.Press button once on the transmitter.

2.The parking lights will flash to indicate the remote start received the signal.

3.The engine will start in approximately 5 seconds.

4.A few seconds after the engine is running, the parking lights will turn on again and climate controls will activate and adjust the vehicles interior temperature to your preset setting.

5.The vehicle will run for a 5 to 30 minute cycle and automatically shut down.

(SAFETY START OPERATION :)

The safety start feature allows you to press the button twice before the vehicle will remote start or remote shut down. (Programming Required)

NOTE: The Remote Start Unit will not start the vehicle if any one of the following conditions exists:

1.The hood is opened.

2.The brake pedal is pressed.

3.The optional remote start enable toggle switch is in the OFF position.

4.The gear selector is in any gear other then “PARK” or “NEUTRAL”

TO TURN OFF THE REMOTE START:

When the engine is running (by remote start), if you want to stop it,

1.Press button once on the transmitter.

6

Image 6
Contents RS-622 System Operations Active Lock Changing the Battery in Your TransmittersXT-42LCD 2-Way XT-33 Transceiver Standard Remote Active UnlockPathway Illumination Chirp IndicatorValet Mode LED DisplayDome Light Convenience Delay & Supervision Ignition Control Door LocksSafety Start Operation To Remote Start the VehicleTo Turn OFF the Remote Start To Override Vehicle from Remote Start Control If installedTemporary Stop Feature EnterShutdown Input for Remote Starter Exit the timer startDisabling the Remote Start System If Optional toggle switch XT-42 LCD Transmitter OperationRemote LCD Icons with Function Battery ReplacementStart Mode Valet Mode Door LockProgram Mode for LCD Remote Control Transceiver Program ModeIgnition On Driver paging Vibration / Melody Mode For Regular Remote Control TransmitterFor 2-way LCD Remote Control Transceiver Back to first Car OperationScreen Lamp on Clear the Flash Icon and Melody SoundStop The Trigger Melody Sound Limited Lifetime Warranty Provisions See note below regarding product installationAuto Page Warranty Perchlorate Material Special handling may apply Page Knox Street Unit B, Torrance, CA