Auto Page RS-622 manual Exit the timer start, Shutdown Input for Remote Starter

Page 8

Exit the timer start:

Timer start can be exited manually as follows:

1.Repeat the Enter Steps from above.

Or

1.Make sure the remote start system is not operating the engine.

2.Turn the ignition on. The LED and parking light will flash (4) times. The siren chirps (4) times.

SHUTDOWN INPUT FOR REMOTE STARTER:

If any of the following conditions exist while the system is operating, the engine will not start or will shut down immediately:

1.The hood is opened.

2.The brake pedal is pressed.

3.The optional remote start enable toggle switch is in the OFF position.

4.Engine is over-revved. {“Tachometer checking type” only}

5.The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.

6.Transmitter button is pressed.

7.The vehicle refused to start running after {3} unsuccessful attempts.

DISABLING THE REMOTE START SYSTEM: (If Optional toggle switch

is installed)

This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an enclosed area. To disable the remote start, move the optional remote start enable toggle switch to the OFF position. Valet mode can also be used.

XT-42 LCD TRANSMITTER OPERATION:

LCD REMOTE CONTROL TRANSMITTER:

8

Image 8
Contents RS-622 System Operations Changing the Battery in Your Transmitters XT-42LCD 2-Way XT-33 Transceiver Standard RemoteActive Lock Active UnlockChirp Indicator Valet ModePathway Illumination LED DisplayDome Light Convenience Delay & Supervision Ignition Control Door LocksTo Turn OFF the Remote Start Safety Start OperationTo Remote Start the Vehicle If installed Temporary Stop FeatureTo Override Vehicle from Remote Start Control EnterExit the timer start Disabling the Remote Start System If Optional toggle switchShutdown Input for Remote Starter XT-42 LCD Transmitter OperationBattery Replacement Start Mode Valet ModeRemote LCD Icons with Function Door LockIgnition On Driver paging Program Mode for LCD Remote Control TransceiverProgram Mode For Regular Remote Control Transmitter For 2-way LCD Remote Control TransceiverVibration / Melody Mode Back to first Car OperationStop The Trigger Melody Sound Screen Lamp onClear the Flash Icon and Melody Sound Limited Lifetime Warranty Provisions See note below regarding product installationAuto Page Warranty Perchlorate Material Special handling may apply Page Knox Street Unit B, Torrance, CA