Sony MZ-E707 service manual Section, General

MZ-E707

The Player

1 2

9C

8D

E

F

7

1./x/> N button

2 3 Color Info-LED

3 GROUP button

4 HOLD (Locking the control) switch

5 i (earphones) jack

6 OPEN switch

7 Terminals for charging stand/ dry battery case (at the bottom)

8 VOL +/– button

9 Battery compartment

The earphones with a remote control

A
B
C		H
D
		I
E	J	+
F		–
		K
G
		L

1Headphones/earphones

2 Stereo mini plug

3 X (pause) button

4 SOUND button

5 RPT/ENT (Repeat/Enter) button

6 PLAYMODE button

7 DISPLAY button

8 x (stop) button*

9 Control (./N>) q; Control VOL +/–

Pull and turn to adjust the volume. qa HOLD (Locking the control) switch qs Display window

*The stop button also operates as the enter button, depending on the function.

The display window of the remote control

AB CD E F

G

1Track number display

2Charactor information display

3 Disc indication

4 Alarm indication

5 Play mode indication

6 Battery level indication

7 SOUND indication

The battery charging stand

C A

B

1Terminals for charging

2 CHARGE lamp

3DC IN (3V jack) (at the rear)

SECTION 2	This section is extracted from
GENERAL	instruction manual.

Playing an MD

1Insert an MD.

1 Slide OPEN to open the lid.	2 Insert an MD.	3 Close the lid.
	3
1		2

Insert an MD with the lable side facing up, pushing the

MD to the direction of the arrow in the illustration.

2Play an MD.

2 VOL+

VOLUME +/–
GROUP	VOL–
	1N>
	X
3 Color Info-LED1)	.
> N	x
x	.

1Turn the control towards N> on the remote control (or press > N on the player) to play the disc.

A short beep sounds in the headphones/earphones when using the remote control. The LED flashes and then lights up.

2Pull and turn VOL +/– on the remote control (or press VOLUME +/– on the player) to adjust the volume.

The volume indicator appears in the display, allowing you to check the volume level. After you adjust the volume, push back the control.

To stop play, press x.

Playback starts from the point you last stopped playing. To start playback from the beginning of the disc, turn and hold the control towards N> on the remote control (or hold down > N on the player) for 2 seconds or more.

1)The LED indicates the current operating status by the lighting up in the following colors. When the battery power is exhausted, the LED starts flashing. For more details, see “When to replace or recharge the battery.”

LED color	Operating status
Red	Normal play (The LED lights up continuously)
Green	Group mode* (The LED lights up continuously)
Orange	Group skip mode* (The LED lights for about 5 seconds)

*For more details, see “Using the group function.”

To	Do this (Beeps2) in the headphones)
Find the beginning of	Turn the control towards . on the remote control once
the current track or	(three short beeps). (Or press . on the player once.)
the previous track3)	Turn the control towards . on the remote control repeatedly
	(continuous three short beeps). (Or press . on the player
	repeatedly.)
Find the beginning	Turn the control towards N> on the remote control (two
of the next track4)	short beeps).
	Press > N on the player once.
Go backwards	Turn and hold the control towards . on the remote control.
while playing	Hold down . on the player.
Go forward	Turn and hold the control towards N> on the remote control.
while playing	Hold down > N on the player.
Pause	Press X on the remote control (continuous short beeps).
	Press X on the remote control again to resume play.
Remove the MD	Press x, and then slide OPEN.5)

2)You can turn off the beep sound. For more details, see “Turning off the beep sound.”

3)If you turn the control towards . on the remote control (or press . on the player) during the first track of the disc, the player goes to the beginning of the last track on the disc.

4)If you turn the control towards N> on the remote control (or press > N on the player) during the last track of the disc, the player goes to the beginning of the first track on the disc.

5)If you open the lid, the playback will begin from the beginning of the first track (except when disc information is stored to the personal disc memory or when group mode is on).

z

The MZ-E707 supports the newly developed DSP TYPE-R for ATRAC.

It thus allows you to enjoy TYPE-R high-quality sound from MDs recorded in SP stereo on TYPE-R- equipped MD decks, etc.

Note

When removing the disc, make sure to press x first, and then slide OPEN.

Viewing the display window of the remote control

Track number Track name6) or elapsed time of the track

6)Appears only with MDs that have been electronically labeled.

z

•The player can play the track recorded by 2 ⋅ or 4 ⋅ long playing mode (LP2 or LP4). Normal stereo playback, LP2 stereo playback, LP4 stereo playback or monaural playback is automatically selected to match the audio source.

•The display on the remote control will turn off shortly after you press x.

4