Connections

Caution

•This unit is designed for negative ground 1°- V DC operation only.

•Be careful not to pinch any wires between a screw and the body of the caz or this u_t or between any moving i_rt_ such as fl_eseat railing, etc.

•Before malting connections, di_onnect the ground terminal of the car battery to avoid short drcuits.

•Connect _e yellow and red power input teaclsonly after all other leads have been connected.

•Be sure to connect the red power input lead to the positive 12 V power terminal which i_ energized

when the tgni_on _ is in the acc_ssozT,it_on.

° Run all ground wires to a common ground point.

•Connect bheye_ow cord to a free car cLrc_t rated higher than the unit'sfuse z_lzng. If you connectthis unit Jn serie_ with other stereo components, the car circuit the" are connected to must be rated higher than the sum of the individua) component'sfu_e rating. If there are no car circuits rated a_ high as the unit'sfuserating, coz_nectthe unit directly to _e battery. If no car c_rcuiteare av_lable for cormecl_ng

this unit, connect the unit to a car cLrcuit rated hi._ er than the u_t'_fuse rating in sLtCha way that if the unit blows its fu_e, no other circuits will be cut off.

Warning when installing in a car without ACC(accessory)position on the ignition key switch

Be sure to press (_	on the unit for two seconds to torn off the clock display aSter turned off the
engine.
When you press _	momentarily, the dock d_spl_y does not turn off and th_s causes batten, wear,

Reset button

When the L_st_[at_on and connections are complete, be sure to p_s the reset button with a ball-point

pen, etc.

Notes of connection example

Notes on the €ontm/and povRr supp/y leads

•l_e power antenna control lead (blue) supplies +12 V DC when you turn on the unit.

•When your car has a built-in FM/AM antenna in the rear/side glass, it is necessary to connect the power antenna control lead (blue) or the accessory power input lead (red) to the power termina I of the extsTing antenna boosten For details, consult your deale_

•A power antenna Without a relay box cannot be u_ed with th_ uni_

Memo_ hold connection

When the yellow power input lead is €onn_cte_ power wi# always be rupplled to th_ memory circuit even when the ignition switch i_ turned of_

Notes on speaker connecdon

•Before connecting the speaker;, turn the unit off.

•U_e speakers with an impedance of 4 to 8 ohn_. and with adequate power handling ,apecltle_ Otherwise, the speaker may be damagect

•Do not connect 11_ terminals of the _peaker system to the car chassis, and do not connect the terminals of the right speaker with those of the le_ speaker.

•Do not attempt to _onnect the zpeaker_ it_ parallel.

•DO not connect any _tfve speakers (with buitt_n amplifien) to the speaker terminals of the unit. Doing so may damage the active speakers. Be _ure to connect pesdve speakers to these terminals.