Sony CDX-GT290 Removing the unit Specifications, Remove the protection collar, Remove the unit

Car audio and car goods internet store Winauto

Removing the unit Specifications

1Remove the protection collar.

1 Detach the front panel (page 5).

2 Pinch both edges of the protection collar, then pull it out.

X

Tuner section

FM

Tuning range:

87.5– 108.0 MHz (at 50 kHz step)

87.5– 107.9 MHz (at 200 kHz step)

FM tuning interval: 50 kHz/200 kHz switchable

Antenna (aerial) terminal:

External antenna (aerial) connector Intermediate frequency: 150 kHz Usable sensitivity: 10 dBf Selectivity: 75 dB at 400 kHz Signal-to-noise ratio: 70 dB (mono) Separation: 40 dB at 1 kHz Frequency response: 20 – 15,000 Hz

MW

Tuning range:

		531 – 1,602 kHz ( t 9 kHz step)
		530 – 1,710 kHz ( t 10 kHz step)
	MW tuning interv l: 9 kHz/10 kHz switchable
	Antenna ( eri l) termin l:
		Extern l ntenna ( erial) connector
	Intermediate freq ency: 25 kHz
	Sensitivity: 26 µV
winauto
2 Remove the unit.	SW
	Tuning range:
1 Insert both release keys simultaneously		SW1: 2,940 – 7,735 kHz
until they click.		SW2: 9,500 – 18,135 kHz
		(except for 10,140 – 11,575 kHz)
	Antenna (aerial) terminal:
		External antenna (aerial) connector
Hook f cing	Intermediate frequency: 25 kHz
inw rds.	Sensitivity: 30 µV
	CD Player section
	Signal-to-noise ratio: 120 dB
	Frequency response: 10 – 20,000 Hz
	Wow and flutter: Below measurable limit
2 Pull the release keys unseat the unit.	Power amplifier section
	Output: Speaker outputs (sure seal connectors)
	Speaker impedance: 4 – 8 ohms
	Maximum power output: 52 W ⋅ 4 (at 4 ohms)
	General
	Outputs:
3 Slide the unit out of the mounting.		Audio outputs terminal (sub/rear switchable)
		Power antenna (aerial) relay control terminal

Power amplifier control terminal

Inputs:

Remote controller input terminal

Antenna (aerial) input terminal

AUX input jack (stereo mini jack)

Tone controls:

Low: ±10 dB at 60 Hz (XPLOD)

Mid: ±10 dB at 1 kHz (XPLOD)

High: ±10 dB at 10 kHz (XPLOD)

14