NWZ-A826/A826K/A828/A828K/A829
SECTION 2 |
|
This section is extracted | |
GENERAL | from instruction manual. |
|
Parts and Controls
Front
BACK/HOME button*1
Press to go up one list screen level, or to return to the previous menu. Press and hold the BACK/HOME button to display the Home menu.
Headphone jack
For connecting the headphones. Insert the jack pin until it clicks into place. If the headphones are connected improperly, the sound from the headphones may not sound right.
WM-PORT jack
Use this jack to connect the supplied USB cable, or optional peripheral devices, such as supported accessories for the
Starts playback and enables navigation of the player’s
Display
The display may vary, depending on functions.
Bluetooth antenna (aerial)
Bluetooth indicator
Indicates the status of the Bluetooth function.
VOL +* /– button2
Adjusts the volume.
BLUETOOTH button
Press and hold to turn on or off the Bluetooth function, and to establish or to end Bluetooth connection.
HOLD switch
You can protect the player against accidental operation by using the HOLD switch when carrying it. By sliding the HOLD switch to the direction of the arrow , all operation buttons are disabled. If you slide the HOLD switch to the opposite position, the HOLD function is released.
OPTION/PWR OFF button*1
Displays the option menu.
If you press and hold the OPTION/ PWR OFF button, screen turns off and the player enters standby mode. If you press any button while the player is in standby mode, the “Now Playing” screen, etc., appears and the player is ready for operation. Furthermore, if you leave the player in standby mode for about a day, the player turns completely off automatically. If you press any button when the player is turned of f, the start up screen appears f irst, then the “Now Playing” screen appears.
Note
The player consumes battery power very slightly even when it is in standby mode. Therefore, the player might turn completely off in a short time, depending on the power remaining in the battery.
Strap hole
Used to attach a strap (sold separately). You can attach the supplied stand and a strap at the same time.
*1 Functions marked with 
on the player are activated if you press and hold the corresponding buttons.
*2 There are tactile dots. Use them to help with button operations.
Rear
RESET button
Resets the player when you press the RESET button with a small pin, etc.
Accessory hole (type I)
Used to attach the supplied stand or the optional accessories.
Using the supplied stand
You can stand up the player using the supplied stand.
Notes
When standing the player with the stand, be careful not to press down or knock the player.
Stand up the player horizontally as shown. Do not stand it up vertically.
5