VTech VT 9162 FCC and IC Regulations, VTech Communications Inc, FCC Part

Page 37

FCC AND IC REGULATIONS

This equipment complies with Parts 15 of the Federal Communications Commission (FCC) rules for the United States. It also complies with regulations RSS210 and CS-03 of Industry and Science Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

A label is located on the underside of the Base Unit containing either the FCC registration number and Ringer Equivalence Number (REN) or the IC registration number and Load Number. You must, upon request, provide this information to your local telephone company.

This equipment is compatible with inductively coupled hearing aids.

Should you experience trouble with this telephone equipment, please contact:

VTech Communications Inc.

SERVICE DEPT. at 1-800-595-9511. In Canada, call VTECH Electronics at 1-800-267-7377.

For repair/warranty information. The telephone company may ask you to disconnect this equipment from the line network until the problem has been corrected.

FCC Part 15

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

The equipment has been tested and found to comply with part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the following measures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

•Connect the equipment into an outlet or on a circuit different from that to which the receiver is connected.

•Consult the dealer or an experienced radio/TV technician for help.

ADDITIONAL INFORMATION

37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Table of Contents Additional Information Important Safety Instructions Parts Check List Parts Check ListHandset Layout Base Unit Layout VolumeMailbox PLAY/STOP Telephone Line JackGetting Started Installation of Battery Pack in HandsetRinger Selection Getting Started Setting UP Your VT9162TONE/PULSE Selection Answering System IntroductionWall Mounting If the display says It means Getting Started Handset DisplayBasic Operation Volume ControlMaking Calls Channel ChangingAnswering Calls Using RedialFlash Hold Receiving and Storing Calls Caller ID/CALL Waiting IDAbout Call History Review Caller IDDeleting Records from Call History Caller ID /CALL Waiting IDDial a Displayed Number Store a Caller ID Record in Phone Book MemoryScreen Display When Display Screen MessagesStore Memory Numbers Phone BookDial Key Delete Numbers Stored in Memory Edit Numbers Stored in MemoryDial Memory Numbers Operation InstallationBelt Clip Answering System Programming Overview Answering System SetupSet Outgoing Message OGM Set Security Code Recording / Playing / Deleting the Out- going Messages OGMSet Audible Message Alert Day and TimeSet Base Ringer On/Off Set Announce OnlySet Number of Rings Toll SaverLeaving a Message Incoming Message Answering System OperationsAn incoming message can be a maximum of 4 minutes Listening to Messages / MemosDeleting Messages Saving MessagesTurning the Answering Machine ON/OFF Check Current Day and Time Changing Speaker VolumeChanging Playback Speed Auto Disconnect for Extension Phone Pick-up Power FailureMemory Full LED displays What it means Answering System OpterationsPlaying Messages Remotely Remote Operation of Answering SystemRepeat Messages During Playback Stop Message Playback Skip Messages During PlaybackMemo Recording Change OGM RemotelyExiting Remote Operation Voice Menu for Remote OperationMaintenance Phone DOESN’T Work AT ALL Case of DifficultyNo Dial Tone YOU Hear Other Calls While Using Your Phone Handset does not Ring When YOU Receive a CallYour Caller Fades in and OUT Common Cure for Electronic EquipmentWhat does this limited warranty cover? Warranty StatementHow do you get warranty service? VTech Communications Inc FCC and IC RegulationsFCC Part FCC and Acta Information Programming/testing of emergency numbersRepair instructions Rights of the telephone companyThis telephone is registered for use in Canada IC Industry CanadaRbrc R Seal Technical Specifications Issued
Top Page Image Contents