Operation
Channel scan
By scanning, you can monitor channels and codes for transmissions and lock in on the
one that interests you. More importantly, you can find someone in your group who has accidentally changed channels and is talking during your scan.
1.To start scanning, briefly press and release the 
button.
2.If you activate scan while the CTCSS code is set to 0, then the radio will check for any activity on each channel, regardless of the CTCSS code in use on that channel.
3.If you activate scan while the CTCSS code is set at 1 to 38, then the radio will check for any activity on each channel, except the CTCSS code 0 in use on that channel.
4.While the radio is scanning, the scan icon will display and the radio will scroll through the channels.
5.When activity is detected on a channel, the radio will stop scanning and you will hear whatever transmissions are detected. The radio’s display will show the channel and CTCSS code on which activity was detected.
6.If you want to respond to the transmission, press 
within 5 seconds and you can respond.
7.The radio will resume scanning after 5 seconds of inactivity on the channel.
8.To stop scanning, briefly press and release 
.
Scan advance
If scan stops on a channel that you don’t want to listen to, briefly
press 
or 
to resume scanning for the next active channel.
Nuisance delete
If scan continuously stops on an undesired channel, press and
hold 
or 
for at least 3 seconds, then release. This will temporarily remove the undesired channel from the scan list.
15