3.5 REMOTE and CONTROL Boards
11.Remove cover and shield cover.
COVER
2
1. Unplug all connectors from TX/RX Board; dismount the board.
PAN HEAD SCREW
M3X6 (9 PCS.)
SHIELD | BINDING SCREW |
COVER | M4X10 (6 PCS.) |
| GASKET |
| MAIN BODY |
| HANGER GASKET |
J4
| J1 |
|
| U27 | U26 |
J2 | TX/RX BOARD |
|
|
| |
J8 | 05P0666 |
|
|
| J11 |
J10 J6 | J9 | J7 |
BOTTOM VIEW
3 1. Solder CONTROL Board and/or REMOTE Board to TX/RX Board.
2.Coat left rear corner and right front corner of CONTROL and REMOTE Boards with silicone sealant (type KE- 348TRTV, FURUNO code no.
3.Fasten CONTROL connector and/or REMOTE connector.
CONTROL BOARD | CONTROL | |
05P0549 | CONNECTOR | |
ASSY. | ||
or | ||
| ||
|
43
1.Mount TX/RX Board.
2.Plug in REMOTE connector and/or CONTROL connector to TX/RX Board.
3.Attach connectors to the TX/RX Board.
4.Attach shield cover.
REMOTE CONNECTOR (16P)
CONTROL CONNECTOR (7P)
BOTTOM
VIEW
J4 J5 J3
J1
U26
TX/RX BOARD
TOP
VIEW
U27 |
GASKET (3) |
GASKET |
U27 U26
PAN HEAD SCREW
M3X10
J2 TX/RX BOARD
FLAT WASHER |
| |
NUT | REMOTE | |
PLUG | ||
CONNECTOR | ||
| ASSY.* |
J8
05P0666
PAN HEAD SCREW
M3X10 (2 PCS.)
J11
PAN HEAD SCREW |
|
| PAN HEAD SCREW |
J10 J6 |
| M3X8 (5 PCS.) |
J9 | J7 |
*Male and female connector attached.
5
1. Attach vinyl tape (approx. 50 mm) to each outside corner of cover.
2. | Insert gasket, and then fix it with vinyl tape at corners of cover. | |
3. | Insert main body to cover. |
|
4. | Remove vinyl tape. |
|
5. | Fasten cover to main body with binding screws. |
|
| COVER | Vinyl tape |
ATTACH VINYL
TAPE
GASKET
Cover
Groove is outside.
Gasket