3.9 Dummy Load
The dummy load enables testing of the
W4 should not touch
TB4 or W3.
Gap between inner wall 
and wire should be more
than 15 mm.
W4 WIRE ASSY.
W3 WIRE ASSY.
NOTICE
Separate wire assemblies W3 and W4 more than
15 mm from each other.
Fasten dummy load assy. to shield case with four existing screws (4 pcs.).
TB4
ANT
Fasten wire with cable tie.
|
| Separare these wires: Bend | |
|
| lug attached to TB1 upward; bend | |
|
| ||
|
| W6 |
|
|
| WIRE ASSY. | |
TB2 | TB1 | TB3 | NOTICE |
TX | TX | DUMMY | |
OUT | IN |
| Do not route |
|
| J1 | |
|
| wires within | |
DUMMY CONT | J2 | ||
| this area. | ||
BOARD 05P0670 | E | ||
|
|
| |
|
| TB4 |
|
DUMMY LOAD ASSY. | E TB3 | ||
| |||
W5
WIRE ASSY.