Locating the Furnace

18"

6" CHIMNEY

1. The furnace should be located in the

same room as the central system

and as close as possible, but not

12"9"

CENTRAL

closer than 9". There should be no

wall between the furnace and the

warm air outlet duct that is connected

directly to the warm air outlet plenum

of the central furnace. (See Fig. 2)

2. The unit will require installation with

the following clearances:

Unit to sidewall	12"(305mm)
Unit to backwall	30"(760mm)

Chimney connector pipe to sidewall

.....................................18"(460mm)

Chimney connector pipe to backwall

.....................................18"(460mm)

Hot air ducts to combustibles

.......................................6"(150mm)

(Refer to Fig. 2 & 3)

3.Place the furnace on a noncombus- tible floor.

4.Check figures 2 and 3. Be sure you have the clearances shown from the furnace and the connector pipe to combustible surfaces. If you have a solid brick or stone wall behind your furnace, you can place the furnace as close as you wish to the wall. If the wall is only faced with brick or stone, treat it as a combustible wall.

FURNACE

48"

Figure 2

18"

6" SOLID DAMPER

6" BAROMETRIC

DRAFT REGULATOR

(OPTIONAL)

18"

NON-COMBUSTIBLE FLOOR

Figure 3