AT&T 555-600-736 manual Ttr

Page 34

- 32 -

 

MODULE

LINE/TRUNK

STATION TYPE

SPECIFICATIONS

 

 

 

TYPE

 

 

 

 

 

 

 

 

 

 

012 (T/R)

n/a

Single-line telephone;

Capacity: 12 T/R stations

 

 

 

 

MERLIN attendant;

on 2-way voice transmission path

 

 

 

 

MERLIN MAIL Voice

with support for telephones with

 

 

 

 

Messaging System T/R

message-waiting LEDs. 2 TTRs

 

 

 

 

adjunct (such as an

Power: 21-VDC, 600-ohm

 

 

 

 

answering machine or fax

battery source

 

 

 

 

machine); analog data

Ringing current: 105-Vrms,

 

 

 

 

device (such as a

30-Hz sinusoidal ringing

 

 

 

 

modem)

superimposed on -48 VDC; a ring

 

 

 

 

 

generator must be installed

 

 

 

 

 

in the power supply module of

 

 

 

 

 

each carrier that has a 012

 

 

 

 

 

module

 

 

 

 

 

REN: <1.0 per port

 

 

 

 

 

Disconnect signal: 900 ms

 

 

 

 

 

(T/R short for answering

 

 

 

 

 

machines, G3 Fax etc)

 

 

 

 

 

Switchhook flash detection:

 

 

 

 

 

300-1200 ms

 

 

 

 

 

 

 

 

100D DSI

T-1 or PRI

n/a

Capacity: 24 lines/trunks

 

 

 

 

 

for voice and analog data or 23

 

 

 

 

 

lines/trunks for voice and data

 

 

 

 

 

with 1 channel used for signaling.

 

 

 

 

 

Mode: multiplexes 24 or 23

 

 

 

 

 

line/trunks into 1 facility and

 

 

 

 

 

demultiplexes 1 facility into 23

 

 

 

 

 

or 24 lines/trunks

 

 

 

 

 

speed: Up to 64 kbps

 

 

 

 

 

Signalling: DS1 over 4-wire;

 

 

 

 

 

T-1 uses robbed-bit or common

 

 

 

 

 

channel; PRI has ISDN-PRI -

 

 

 

 

 

(23B + 1 D)

 

 

400/TTR*

Loop-start

Power failure transfer

Capacity: 4 lines/trunks.

 

 

 

and TTR

(PFT) telephone

4 TTRs. 1 PFT telephone

 

 

 

 

 

Signaling: Loop-start

 

 

400 E&M

Tie trunk

n/a

Capacity: 4 tie lines

 

 

 

 

 

Method of completion:

 

 

 

 

 

automatic start, immediate-start.

 

 

 

 

 

wink-start, or delay-did-start

 

 

 

 

 

Signaling: E&M type IS.

 

 

 

 

 

type 1C. type 5

 

 

 

 

 

 

 

 

400 GS/LS/TTR

Loop-start or

PFT telephone; button

Capacity: 4 lines/trunks,

 

 

 

ground-start and

needed for ground-sun

4 TTRs, 1 PFT telephone

 

 

 

TTR

PFT telephone

signaling: Loop-start or

 

 

 

 

 

ground-start, optioned per port

 

 

 

 

 

 

 

 

 

 

 

 

 

Image 34
Contents AT&T Merlin Legend Communications System Application Notes Page Merlin Legend Trunking Concepts Application Note Index Introduction to Trunking Concepts TIP and Ring ExplainedLines and Trunks LOOP-START Trunks Operations LOOP-START Trunks POTENTIAL-PROBLEMS Problem of GlareAutomated Attendant Ghost Calls and Loop-Start Facilities Proper Loop-Start Facility Applications LOOP-START Trunks When to USE LOOP-START TrunksUnavoidable Loop-Start Facility Applications Cost GROUND-START Trunks Operations GROUND-START Trunks Potential Problems GROUND-START Trunks When to USE GROUND-START TrunksDirect Inward Dialing did Trunks Operational Characteristics Did Trunk Signaling Characteristics Types of Loop Reverse-Battery SignalingAdministration Considerations in Using did Trunks TIE Trunks When to USE did TrunksSimple Tie Trunk Operation Tandem Tie Trunk Operation TIE Lines Signaling and ImplementationTransferring Calls P E Transmit C E I V E ON-HOOK OFF-HOOK OFF Premises Stations Page DS1 Service Overview and OperationsDESIGN, Signaling & Implementation Potential Problems/LimitationsData Communications Equipment Do GBS Customers Need T-1?Channel Service Unit CSU Multiplexer MUX DS1 Facility Services IsdnSDN SID/ANI Special HOTEL/MOTEL Trunks Maintenance and TroubleshootingOperation Overview Hardware Module LINE/TRUNK Station Type Specifications TTR Trunk analog voice Reusable Modules from Merlin II R3 Administration ConsiderationsReferences