PART | R0707A |
To locate the parts listed below, see the EXPLODED DRAWING near the end of this manual.
Key No. | Qty. | Description | Key No. | Qty. | Description |
1 | 2 | Foot Rail Decal | 57 | 1 | Base Ground Wire |
2 | 3 | 3/4" Belly Pan Screw | 58 | 1 | Frame |
3 | 29 | Screw | 59 | 1 | Belly Pan |
4 | 1 | Reset/Off Circuit Breaker | 60 | 4 | |
5 | 10 | Foot Rail Screw | 61 | 1 | Reed Switch Clip |
6 | 2 | Isolator | 62 | 2 | Handrail Endcap |
7 | 12 | 3/4" Screw | 63 | 1 | Reed Switch |
8 | 8 | Star Washer | 64 | 4 | Handrail Bolt |
9 | 2 | Platform Bolt, Back | 65 | 2 | 2.5" Extension Leg Bolt |
10 | 2 | Platform Bolt, Front | 66 | 2 | Star Washer |
11 | 4 | Belt Guide Screw | 67 | 2 | Extension Leg Nut |
12 | 2 | Belt Guide | 68 | 2 | Caution Decal |
13 | 1 | Power Cord Grommet | 69 | 1 | Warning Decal |
14 | 2 | Front Endcap Screw | 70 | 2 | Platform Nut |
15 | 2 | Frame Pivot Bolt | 71 | 9 | Cable Tie |
16 | 1 | Left Foot Rail | 72 | 1 | Lower Incline Motor Bolt |
17 | 1 | Right Foot Rail | 73 | 1 | Latch Housing |
18 | 1 | Motor Clevis Pin | 74 | 2 | Rear Roller Lock Washer |
19 | 1 | Motor Bracket | 75 | 1 | Releasable Tie |
20 | 1 | Handrail | 76 | 1 | Access Door |
21 | 1 | Latch Pin Assembly | 77 | 1 | Wire Harness |
22 | 2 | Motor Washer | 78 | 2 | Extension Leg Endcap |
23 | 1 | Motor Star Washer | 79 | 1 | Key/Clip |
24 | 2 | Motor Bolt | 80 | 2 | Front Wheel |
25 | 2 | Motor Tension Bolt | 81 | 2 | Wheel Pin |
26 | 1 | Motor Belt | 82 | 2 | Base Pad |
27 | 1 | Drive Motor | 83 | 4 | 1" Tek Screw |
28 | 2 | Frame Spacer | 84 | 1 | Upright |
29 | 2 | Endcap Base Pad | 85 | 1 | Console Base |
30 | 2 | Motor Nut | 86 | 1 | Upper Incline Motor Bolt |
31 | 2 | Lift Frame Bolt | 87 | 1 | Hair Pin Cotter Pin |
32 | 6 | Lock Nut | 88 | 1 | Incline Motor |
33 | 9 | Ground Screw | 89 | 2 | Extension Leg |
34 | 1 | Console | 90 | 2 | Rear Roller Bracket |
35 | 2 | Fan Screw | 91 | 2 | Rear Roller Flat Washer |
36 | 1 | Power Cord | 92 | 2 | 2.25" Extension Leg Bolt |
37 | 1 | Console Fan | 93 | 1 | Optic Disk |
38 | 1 | Controller | 94 | 1 | Photo Switch Nut |
39 | 1 | Electronic Bracket | 95 | 2 | Rear Roller Bracket Screw |
40 | 1 | Filter Wire | 96 | 1 | Photo Switch |
41 | 1 | Hood | 97 | 1 | Photo Switch Bolt |
42 | 1 | Front Roller Bushing | 98 | 3 | Hood Clip |
43 | 1 | Lift Frame | 99 | 1 | Latch Plate |
44 | 2 | Front Endcap | 100 | 10 | Wire Tie |
45 | 1 | Front Roller Bolt | 101 | 1 | Roller Ground Wire |
46 | 1 | Magnet | 102 | 1 | Photo Switch Wire |
47 | 1 | Front Roller | 103 | 1 | Front Roller Nut |
48 | 1 | Walking Belt | 104 | 1 | #10 x 3/4" Screw |
49 | 1 | Walking Platform | * | – | 4" Blue Wire, 2F |
50 | 1 | Incline Motor/Controller Wire | * | – | 10" Red Wire, M/F |
51 | 1 | Rear Roller | * | – | 12" Blue Wire, 2F |
52 | 1 | Left Rear Endcap | * | – | 8" Black Wire, M/F |
53 | 2 | Rear Roller Bolt | * | – | 12" Blue Wire, M/F |
54 | 1 | Right Rear Endcap | * | – | User’s Manual |
55 | 1 | Hex Key | *These parts are not illustrated. | ||
56 | 1 | Incline Stop Bracket | Specifications are subject to change without notice. |
23