5.Identify the Right Pedal (63), which has an “R” molded into its bottom surface.
Attach the Right Pedal (63) to the Right Pedal Tube (64) with two M8 x 1 9/16" Hex Bolts (41), two M8 Washers (52), and two M8 Nylon Locknuts (57).
Attach the Left Pedal (not shown) to the Left Pedal Tube (not shown) in the same way.
6.Apply a small amount of the included grease to the parts shown at the right.
Attach the Right Pedal Tube (64) to the Right Handlebar Leg (71) with an M8 x 2 1/2" Shoulder Hex Bolt (40), an M6 Washer (55), and an M6 Nylon Locknut (56).
Repeat this step to attach the Left Pedal Tube (not shown) to the left side of the ellip- tical exerciser.
5 | 41 |
|
|
| 63 |
| |
|
|
| |
52 | 57 | 52 64 |
|
|
| ||
6 |
| 71 |
|
| 56 55 |
| |
| 64 |
| |
|
| 40 |
7.Insert a Plastic Sleeve (16) into the top of the Right Handlebar Leg (71). Then, insert a Handlebar (6) into the Right Handlebar Leg. Align the holes in the Handlebar with the holes in the Right Handlebar Leg. Attach the Handlebar with two M6 x 5/8" Pocket Screws (46), two M6 Arc Washers (39), and two M6 Nylon Locknuts (56).
Attach the other Handlebar (6) to the Left Handlebar Leg (5) in the same way.
8.Make sure that all parts of the elliptical exer- ciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser.
7
6 |
| 6 |
|
| 16 |
| |
5 | 39 | 56 | |
46 | 39 | 71 |
|
|
|
|
7