3. While another person holds the Upright (3) near the Frame (1), connect the Upper Wire (75) to the Reed Switch Wire (67). Next, connect the Resistance Cable (12) to the Lower Cable (70) in the following way:
See drawing A. Pull up on the metal bracket
(A) on the Lower Cable (70), and insert the tip of the Resistance Cable (12) into the wire clip located inside the metal bracket.
See drawing B. Firmly pull the Resistance Cable (12) and slide it into the metal bracket (A) on the Lower Cable (70) as shown.
See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket
(A) together.
Slide the Upright (3) onto the Frame (1). Be careful to avoid pinching the cables or the wires. Align the holes in the Upright with the holes in the Frame. Attach the Upright with six M8 x 5/8" Hex Bolts (45) and six M8 Arc Washers (54).
4.The Console (22) requires two 1.5V “AA” batter- ies (not included). Remove the battery cover from the Console and insert two batteries into the battery compartment. Make sure that the batteries are oriented as shown by the dia- gram inside the battery compartment. Then, reattach the battery cover.
Have a second person hold the Console (22) near the Upright (3). Connect the console wire to the Upper Wire (75). Connect the two pulse wires on the console to the Pulse Wires (74). Insert the excess wire downward into the Upright.
Attach the Console (22) to the Upright (3) with four Console Screws (68). Be careful to avoid pinching the wires.
3 | 45 |
|
| 3 54 |
| |
| 54 |
|
|
| ||
|
|
| 45 |
| ||
| 45 |
|
|
| ||
| 12 | 75 | 54 |
| ||
|
|
|
| |||
|
| 70 | 67 |
|
| |
|
| B | 1 | C |
| |
A | A |
|
| |||
| A | 12 | A | |||
1270 | ||||||
| 70 |
|
| |||
4 | 22 |
|
| Battery |
| |
|
| Compartment |
| |||
|
|
| Console Wire |
| ||
| Pulse Wires | 74 | 75 | 3 |
| |
|
|
| ||||
|
|
| 68 |
| ||
|
|
|
|
| ||
6