Lumex Syatems US0208 user manual SPECIFICATIONS, ALL Models

Page 14

5 SPECIFICATIONS, ALL MODELS *

* Specifications are subject to change without notice.

Deck	High position
height
		Deck height: High Position
	US0208/US0208PL:	US0458/US0458PL with cast-	US0458/US0458PL with
	24.0 inches	ers in low position: 20.0 inches	casters in standard position:
			23.5 inches
	Low position
		Deck height: Low Position
	US0208/US0208PL:	US0458/US0458PL with cast-	US0458/US0458PL with
	15.0 inches	ers in low position: 9.5 inches	casters in standard position:
			13 inches
Bed length		Bed Length

Note: To extend grid length (80 in.) to 84 in., install optional kit 690-0084-000

(all beds).

All models: 87.0 inches

Deck width					Deck Width

	All models: 36.0 inches
Weight *	Normal operating conditions	450 lb., evenly distributed including mattress, accessories, rails, etc.

	* Maximum patient weight	350 lb.

Construction	Frame	10 ga (.135) high strength, low alloy steel (roll formed)
	Sleeping surface	11 ga (.120) cold rolled steel

Finish	5 stage bath	1.	S21F acid bath (cleans grease and oil from metal).
		2.	Fresh water rinse.
		3.	QuiliPhos 20 phosphate coat (inhibits rust and helps maintain
		electrical charge during powder application).
		4.	Fresh water rinse.

		5.	QuiliRinse 404 (seals metal for powder coating).

All parts are then coated with a colored epoxy powder and baked 35 minutes at 375 degrees F. The powder coating finish is approximately 2.5 mils thick. The coating is smooth, uniform finish without runs, wrinkles, or grit.

US0208-INS-LAB-RevB09 • Patriot™ Homecare Bed

14

Image 14

Contents US0208-INS-LAB-RevB09 Contents Safety GRAVITY-DOWN Feature for Head and Knee Elevation Thermal Motor ProtectionAssembly Instructions Head and Foot AssemblyRemove motor slide caps Motor AssemblyInstall Motors FULL-ELECTRIC BED only US0458/US0458PL Caster Position Install motor slide capsMotor assembly troubleshooting Standard conventional bed heightBED END Assembly All bed models Assemble bed endsAll models Assemble head bed end Full-electric bed only US0458/US0458PL Assemble hi/lo rod HI/LO ROD Assembly / BED LengthSemi-electric bed only US0208/US0208PL Assemble hi/lo rod All models Attach HI/LO rod to gearbox or motor shaft pins Foot ENDFull-electric bed only US0458/US0458PL BED OperationPendant Hand Control Operation Semi-electric bed onlyCrank Operation SEMI-ELECTRIC BED only US0208/US0208PL SPECIFICATIONS, ALL Models Lumex Patriot Liberty BED Rails Accessories BED RailsBED Rail Safety GF6500B-1 Assist BarGF6570B-1 Full Length Rail Lumex Standard BED RailsGF6590B-1 Half No-Gap Head Rail GF6570A-1 Full Length Side RailLX5088 No-Gap Bed Rail GF6580A-1 Low Universal Half RailPart number Description Semi-electric Full-electric Service PARTS, ALL ModelsBED Components BED END Components BED Service Parts Part number DescriptionMaintenance and Safety Checks Warranty Index A. Corporate Headquarters GF Health Products, Inc