Lumex Syatems US0208 FULL-ELECTRIC BED only US0458/US0458PL Caster Position, Low bed height

Page 7

Install motor slide caps

7.Position the caps as shown at right so that the grooves in the slide cap are aligned with the grooves in the motor.

8.Apply straight downward pressure to each end of the cap while sliding into the closed position.

9.Repeat step 8 for the other cap.

10.Ensure that all four corners of each slide cap are engaged.

pressure

slide cap

motor

Install motor slide caps

WARNING: Ensure that the motor is assembled on bed as instructed above before use.

Motor assembly troubleshooting

Problems associated with improper motor installation are listed below, with appropriate fix.

Problem

Probable cause

Fix

 

 

 

Head operates with knee control button and

Motor is installed backwards

Remove motor and reverse it (see page 7)

knee operates with head control button

 

 

 

 

 

Knee lifting linkages bind against grid

Motor is installed backwards, enabling

Remove motor and reverse it (see page 7)

deck, preventing knee deck from elevating.

knee to elevate too high and bind linkage

 

FULL-ELECTRIC BED ONLY (US0458/US0458PL): CASTER POSITION

Any full-electric Patriotbed can be used as either a standard-height or low-height bed by moving the casters.

fig 1: casters mounted at

fig 2: casters mounted at low

standard height

height, bed in lowest position

fig 3: casters mounted at low height, bed in elevated position

Standard (conventional) bed height

To achieve standard bed height, insert casters into outside legs, as shown in fig. 1 above.

Low bed height

To achieve low bed height, insert casters into inner short legs, as shown in figs. 2 and 3 above. When in the lowest position, the casters are engaged for bed movement, as shown in fig. 2 above. When elevated, the bed is off the casters and cannot be moved, as shown in fig. 3 above.

Due to the clearances involved, only minor travel and movement are recommended in the low po- sition. The casters can be moved to the outer legs to provide clearance if the bed must be moved or rolled.

US0208-INS-LAB-RevB09 • PatriotHomecare Bed

7

Image 7
Contents US0208-INS-LAB-RevB09 Contents Safety Thermal Motor Protection GRAVITY-DOWN Feature for Head and Knee ElevationHead and Foot Assembly Assembly InstructionsInstall Motors Motor AssemblyRemove motor slide caps Standard conventional bed height Install motor slide capsMotor assembly troubleshooting FULL-ELECTRIC BED only US0458/US0458PL Caster PositionAll bed models Assemble bed ends BED END AssemblyAll models Assemble head bed end Semi-electric bed only US0208/US0208PL Assemble hi/lo rod HI/LO ROD Assembly / BED LengthFull-electric bed only US0458/US0458PL Assemble hi/lo rod Foot END All models Attach HI/LO rod to gearbox or motor shaft pinsSemi-electric bed only BED OperationPendant Hand Control Operation Full-electric bed only US0458/US0458PLCrank Operation SEMI-ELECTRIC BED only US0208/US0208PL SPECIFICATIONS, ALL Models GF6500B-1 Assist Bar Accessories BED RailsBED Rail Safety Lumex Patriot Liberty BED RailsGF6570A-1 Full Length Side Rail Lumex Standard BED RailsGF6590B-1 Half No-Gap Head Rail GF6570B-1 Full Length RailGF6580A-1 Low Universal Half Rail LX5088 No-Gap Bed RailBED Components Service PARTS, ALL ModelsPart number Description Semi-electric Full-electric BED END Components Part number Description BED Service PartsMaintenance and Safety Checks Warranty Index A. Corporate Headquarters GF Health Products, Inc