Make sure that your thumb is positioned as shown, and that you are applying the proper amount of pressure to the pulse sensor. Try the sensor several times until you become familiar with it.
5.To turn off the power, wait for about four minutes.
Note: The monitor has an
the pedals are not moved and the console but- tons are not pressed for four minutes, the power will turn off automatically in order to conserve the batteries.
MAINTENANCE AND STORAGE
Inspect and tighten all parts of the exercise cycle reg- ularly. The exercise cycle can be cleaned with a soft, damp cloth. To prevent damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
CRANK ADJUSTMENT
If the arms of the |
| |
Crank (8) become |
| |
loose, they should |
| |
be tightened in | Slotted | |
order to prevent | ||
Crank Nut | ||
excessive wear. |
| |
Loosen the Hex | 14 | |
Crank Nuts (14) | ||
8 | ||
on the left arm of | ||
the Crank. Place |
| |
the tip of a stan- |
|
dard screwdriver in one of the slots in the slotted crank nut. Tap the screwdriver with a hammer to turn the slotted crank nut counterclockwise until the arms are no longer loose. Do not overtighten the slotted crank nut. When the slotted crank nut is properly tightened, tighten the Hex Crank Nuts.
HOW TO ADJUST THE REED SWITCH
If the console |
| 13 |
does not dis- | 39 | |
play correct | 20 | |
| 8 | |
feedback, the |
| |
|
| |
reed switch |
|
|
may need to |
|
|
be adjusted. |
| 13 |
To adjust the |
| 13 |
reed switch, |
| |
|
| |
you must first |
|
|
remove the |
|
|
Left Side |
| 5 |
Shield (20). |
|
|
Using an |
|
|
adjustable wrench, turn the Left Pedal (39) clockwise | ||
and remove it. Next, remove the indicated M4 x 12mm Screws (5) and M4 x 38mm
Turn the left arm of the Crank (8) to the position shown, and carefully slide the Left Side Shield forward and remove it.
With the left side shield removed, locate the Reed Switch (42) (see the drawing below). Turn the Crank
(8)until the Magnet (61) is aligned with the Reed Switch. Loosen but do not remove the M4 x 16mm Screw (43). Slide the Reed Switch slightly closer to or farther away from the Magnet. Retighten the Screw. Turn the Crank for a moment. Repeat until the con- sole displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left side shield and the left pedal.
61 | 42 |
| 43 |
| 8 |
| Front |
| View |
BATTERY REPLACEMENT
If the console does not function properly, the batteries should be replaced. See assembly step 3 on page 6.
TIGHTENING THE PEDALS
For best performance, regularly tighten both pedals.
11