ASSEMBLY
Make Things Easier for Yourself
This manual is designed to ensure that the weight bench can be assembled successfully by anyone. Most people find that by setting aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the following information and instructions:
•Assembly requires two people.
•For help identifying small parts, use the PART IDENTIFICATION CHART on page 5.
•Tighten all parts as you assemble them, unless instructed to do otherwise.
•As you assemble the weight bench, make sure all parts are oriented as shown in the drawings.
•Place all parts in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.
The following tools (not included) are required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
•Lubricant, such as grease or petroleum jelly, and soapy water.
Assembly will be more convenient if you have a socket set, a set of
1. Before assembling this product, make sure |
you have read and understand the information |
in the box above. |
Tap two 38mm Square Inner Caps (21) into the |
bottom of each Upright (1). |
Attach the Crossbar (3) to the two Uprights (1) with |
four M8 x 57mm Bolts (18), four M8 Washers (16), |
1
1
16
17
18
Tall side of
Weight Rests
Decal 1
and four M8 Nylon Locknuts (17). Note: The decal |
on the Crossbar, and the tall side of the weight |
rest on the Uprights, must be oriented as |
shown. Do not tighten the Nylon Locknuts yet. |
1618
18 |
| 16 |
3 |
| |
|
| |
21 | 18 | 17 |
|
|
2. Tap three 38mm Square Inner Caps (21) into the |
Front Leg (8). |
Attach the Front Leg (8) to the Frame (2) with two |
M10 x 40mm Bolts (46), two M10 Washers (34), |
2 46
21
21
2
and two M10 Nylon Locknuts (33). Note: Do not |
tighten the Nylon Locknuts yet. |
34
33
8
21
21
6