Weslo WEBE13810 user manual Bracket

11.	Tap a Fly Arm Stop (15) onto the welded tube on	11
	each Upright (1).
	Press two Plastic Bushings (14) into the indicated
	holes in an Upright (1). Attach a Fly Arm (25) to				13
	the Upright using an M10 x 114mm Bolt (19) and			14	14
	a Butterfly Knob (13). Make sure the Fly Arm is				1
	on the outside of the Fly Arm Stop (15).
		19		25
	Attach the other Fly Arm (not shown) to the other
	Upright (not shown) in the same manner.				15
12.	Push a 3/4” Round Inner Cap (9) into the end of a	12
	Short Pad Tube (12). Slide the Short Pad Tube
	into the indicated hole in the a Fly Arm (25), as				12
	shown. Push a Short Foam Pad (27) onto the
	Pad Tube.
	Repeat this step for the other Fly Arm (not		25		9
	shown).
			27
13.	Insert the loop end of the Cable (39) through the	13			21
	hole in the Lat Tower (40) and over the Pulley
			34
	(44). Attach the Pulley, two Spacers (43), and two
			42
	M10 Washers (34) to the Lat Tower with an M10 x				39
	54mm Bolt (42) and an M10 Nylon Locknut (33).		43
					34
	Press a 38mm Square Inner Cap (21) into the top		44		33
	of the Lat Tower (40).
	Press a 1” Round Inner Cap (24) into each end of		43		40
	the weight tube on the Weight Carriage (48).
	Slide a Weight Stop (28) onto each side of the
	Weight Carriage. Press Square Bushings (47)
	into the top and bottom of the Weight Carriage.
	Slide an M10 x 19mm Screw (45) into the bracket
	on the Weight Carriage (48).		45
	Slide the Weight Carriage (48) onto the Lat Tower		39
			33
	(40). Attach the Cable (39) to the M10 x 19mm	28
	Screw (45) with an M10 Nylon Locknut (33). Do				47
	not overtighten the Nylon Locknut; the Cable		24
	must be able to pivot freely.				48
14.	Make sure that all parts are properly tightened		Bracket		24
					28
	before you use the weight bench. The use of
	all remaining parts will be explained in		47
	ADJUSTMENTS starting on the next page.
		9