7. | Tap two 1” Square Inner Caps (35) into each of | 7 | 30 |
|
| the two Backrest Tubes (5). |
| ||
|
|
| ||
| Attach each Backrest Tube (5) to the Backrest (6) |
|
| 35 |
|
| 26 |
| |
| with two M6 x 38mm Screws (30) and two M6 |
|
|
|
| Washers (26). Note: Do not tighten the Screws |
|
|
|
| yet. | 30 | 5 |
|
|
| 26 |
| 6 |
|
| 35 |
|
|
8. | Tap a 3/4” Round Inner Cap (9) into each end of | 8 |
|
|
| the Support Rod (7). Insert the Support Rod |
|
| |
|
| 1 |
| |
| through one of the three upper sets of holes in |
|
| |
|
|
|
| |
| the Uprights (1). Rotate the Support Rod to the |
| 9 |
|
| locked position, with the locking pin wrapped |
| 1 | |
| around the Upright. |
|
|
|
| Lubricate the M10 x 135mm Bolt (36). Attach the | 36 |
| 9 |
| Backrest Tubes (5) to the welded tube on the | 34 |
| |
| Frame (2) with the Bolt, two M10 Washers (34), |
|
| 7 |
| and an M10 Nylon Locknut (33). | 5 | 2 |
|
|
|
|
| |
| Tighten the M6 x 38mm Screws (30) used in |
| 33 |
|
| step 7, and the Nylon Locknuts (17, 33) used |
| 34 |
|
| Welded Tube |
| ||
| in steps |
| ||
|
|
|
| |
9. | Attach the Seat (11) to the brackets on the Frame | 9 |
|
|
11 |
|
| ||
| (2) with four M6 x 16mm Screws (29) and four M6 |
|
|
|
| Washers (26). |
|
|
|
|
|
| 2 |
|
|
|
| 26 |
|
|
|
| 29 |
|
|
|
| 26 |
|
|
|
| 29 |
|
10. | Tap a 30mm Square Inner Cap (22) into each end | 10 |
|
|
| of a Fly Arm (25). Push a 1” Round Inner Cap |
|
| |
|
| 25 |
| |
| (24) into the end of the weight tube. Slide a |
|
| |
|
|
|
| |
| Weight Stop (28) onto the weight tube. |
|
|
|
| Assemble the other Fly Arm (not shown) in the |
|
| 22 |
| same manner. |
|
|
|
|
|
| 24 | 28 |
|
|
|
| |
|
| 22 | Weight Tube |
|
|
|
|
| |
|
| 8 |
|
|