3.HoldtheConsoleBase(87)neartherightHandrail(4).
Makealoopwiththeindicatedplastictie,andinsertthe
twoWires(53)throughtheloop.Pulloutjustenoughof theWirestoconnectthemtothetwoconnectorsinthe
ConsoleBase(87).Plugtheredconnectorintothecorre- spondingconnectorintheConsoleBaseTheconnectors. shouldsnaptogetherwithoutbeingforced.Iftheydonot, rotatetheredconnectorontheWireandtryagain.Next, plugtheotherWireintotheotherconnectoronthe
ConsoleBaseImportant:. Make sure that the Wires (53)
are fully inserted. Do not force the connectors togeth- er. IF THE CONNECTORS ARE NOT INSERTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Do not disconnect or connect
the Wires while the treadmill power cord is plugged in.
Plastic (_
Tie
3a
87
Refer drawing 3a. Set the Console Base (87) on the
Plastic
Handrails (4, 88). Thread four Console Screws (3) into the Handrails and the Console Base. After all four
Screws have been started, tighten the Screws until they are snug; do not overtighten the Screws.
Tie
3
Feed the excess Wire Harness (53) into the upper end | 38 | |||
| ||||
of the right Handrail (4). Pull the | plastic tie tight and cut |
| ||
off the end. |
|
|
|
|
4. Attach the Storage Latch (16) to | the left | Upright | (38) |
|
with two Latch Screws (14). |
|
|
|
|
Refer to step 2. Tighten the four | Handrail | Bolts | (1). |
|
5.Hold a Weight Rack (15) against the right Upright (38) in the position shown. Loosely thread two Rack Screws
(14)into the bottom holes in the Weight Rack and the Upright. Next, loosely thread four Rack Screws into the other four holes. Then, tighten all six Rack Screws.
Set a
Attach the other Weight Rack and Weights to the left
Upright in the same way (not shown).
16
14
15
14
14
Hanger
14
6.Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.