HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the reed switch may need to be adjusted. To adjust the reed switch, you must first remove the left side shield (see HOW TO REMOVE THE LEFT SIDE SHIELD on page 11).
61 | 42 |
| 43 |
| 8 |
| Rear |
| View |
With the left side shield removed, locate the Reed Switch (42). Turn the Crank (8) until the Magnet (61) is aligned with the Reed Switch. Loosen, but do not remove, the M4 x 16mm Screw (43). Slide the Reed Switch slightly closer to or farther away from the Magnet. Retighten the Screw. Turn the Crank for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjust- ed, reattach the left side shield and the left pedal.
HOW TO ADJUST THE RESISTANCE STRAP
If the resistance knob is set on its highest setting and there is not enough resistance, the resistance strap may need to be adjusted. To adjust the resistance strap, you must first remove the left side shield (see HOW TO REMOVE THE LEFT SIDE SHIELD on page 11).
41 |
57 |
15 |
With the left side shield removed, turn the resistance knob to the lowest setting (see HOW TO ADJUST THE PEDALING RESISTANCE on page 9). Open the Strap Clamp (57) and pull the end of the Resistance Strap (41) slightly upward to increase resistance. Close the Strap Clamp and turn the Flywheel (15) to make sure that there is not too much resistance. When the Resistance Strap is properly adjusted, re- attach the left side shield and the left pedal.
12