Be careful not to, Pinch the wires, Or the cable

5.Connect the Reed Switch Wire (42) to the corre- sponding console wire. Insert the excess wire into the Upright.

Attach the Console (33) to the Upright (3) with four M4 x 16mm Screws (43). Be careful not to pinch the wires or the cable. Press the Resistance Knob (32) onto the Resistance Control (31). Make sure that the mark on the Resistance Knob is correctly aligned.

6.Attach the Seat Upright (64) to the Seat Frame (2) with four M8 x 54mm Carriage Bolts (11), four M8 Flat Washers (51), and four M8 Nylon Locknuts (55). Note: It may be helpful to tip the exercise cycle on its side to attach the Seat Upright.

7.Attach the Stabilizer (30) to the Seat Frame (2) with two M10 x 70mm Carriage Bolts (27) and two M10 Nylon Locknuts (26).

8.Attach the Seat Bracket (63) to the Seat Upright

(64)with four M8 x 66mm Carriage Bolts (52), four M8 Flat Washers (51), and four M8 Nylon Locknuts

5			33
			33
		Console
		Wire	32
43		42	32
43		42
		Be careful not to
		31	pinch the wires
	3	43	or the cable.
		43
6
			11
			64
			11
		2
		51
		55	51
			55
7
			26
		2
		26	30
			27
8
		63
		52	64
			51
			55
			51