Weslo WCTL26080 user manual HOW to Fold and Move the Treadmill, HOW to Select Kilometres and Miles

HOW TO SELECT KILOMETRES AND MILES

The console can display distance and speed in either kilometres or miles. To change the unit of measure- ment, first UNPLUG THE POWER CORD. Next, remove the six screws attaching the console to the console base. Lift the console a few inches, being

careful not to pull on the wires, and turn the console over. Locate the small switch on the back of the con- sole. Move the switch upward or downward to select kilometres or miles. Re-attach the console to the con- sole base. After changing the unit of measurement, remove one of the batteries from the console for about five seconds and then reinsert it. This will reset the console.

HOW TO CHANGE THE INCLINE OF THE TREADMILL

To vary the intensity of your exercise, the incline of the treadmill can be changed. There are three different incline levels. Before changing the incline, remove the key and unplug the power cord.

To change the incline of the treadmill, first hold the rear roller end-

cap with one hand and raise the back of the treadmill a few inches. Using

your other hand, rotate the incline leg to one of the

three incline positions. The inset drawing

at the right shows the incline leg rotated to the “max fat burn” position. This position is ideal for maximum fat burning. For a less intense fat burning workout, rotate the incline leg to the “fat burn” position. For aer- obic exercise, rotate the incline leg to the “aerobic” position. When you have turned the incline leg to the desired position, lower the treadmill. Make sure that the incline leg is resting flat on the floor.