Weslo WETL34709.0 user manual Troubleshooting, Problem The power turns off during use

Page 14

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet (see page 8). Do not use

an extension cord.

 

 

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c. Check the on/off switch located on the treadmill

c

 

frame near the power cord. If the switch protrudes

 

as shown, the switch has tripped. To reset the

Tripped

On

switch, wait for five minutes and then press the

switch back in.

 

 

PROBLEM: The power turns off during use

SOLUTION: a. Check the on/off switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The walking belt slows when walked on

 

 

SOLUTION: a. If the walking belt is overtightened, treadmill perfor-

a

 

mance may decrease and the walking belt may be-

2–3 in.

come damaged. Remove the key and UNPLUG

 

THE POWER CORD. Using the hex key, turn both

 

 

idler roller bolts counterclockwise, 1/4 of a turn.

 

 

When the walking belt is properly tightened, you

 

 

should be able to lift each edge of the walking belt

 

 

2 to 3 in. (5 to 7 cm) off the walking platform. Be

 

 

careful to keep the walking belt centered. Then,

 

 

plug in the power cord, insert the key, and run the

 

Idler Roller Bolts

treadmill for a few minutes. Repeat until the walk-

 

ing belt is properly tightened.

 

 

b. If the walking belt still slows when walked on, see the front cover of this manual.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents QUESTIONS? Model No. WETL34709.0 Serial NoTable of Contents Important Precautions Page Before YOU Begin Assembly See the lower drawing. Pull the Latch KnobAssembly Mended power cord Operation and AdjustmentHOW to Plug in the Power Cord Been tightened before using the power cordConsole Diagram Features of the ConsoleSelect the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Insert the key into the consoleFollow your progress with the display When you are finished exercising, removePower cord. Important If you do not do this On the foot railsHOW to USE a Preset Workout HOW to Change the Incline of the TreadmillHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USEProblem The walking belt slows when walked on TroubleshootingProblem The power turns off during use Problem Solution Lubricating the Walking BeltWorkout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart LIST-Model No. WETL34709.0 Key No. Qty DescriptionExploded Drawing A-Model No. WETL34709.0 R1209B Exploded Drawing B-Model No. WETL34709.0 Ordering Replacement Parts Recycling Information
Top Page Image Contents