Weslo WLTL 14709.0 user manual Troubleshooting, Compatible with GFCI-equipped outlets

Page 14
2–3 in.
Idler Roller Bolts

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppres-

sor that meets all of the specifications described on page 8. IMPORTANT: The treadmill is not

compatible with GFCI-equipped outlets.

 

 

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c. Check the on/off switch located on the treadmill

c

 

frame near the power cord. If the switch protrudes

 

as shown, the switch has tripped. To reset the

Tripped

On

switch, wait for five minutes and then press the

switch back in.

 

 

PROBLEM: The power turns off during use

SOLUTION: a. Check the on/off switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 8.

b. If the walking belt is overtightened, treadmill perfor- b mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG

THE POWER CORD. Using the hex key, turn both idler roller bolts counterclockwise, 1/2 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.

c. If the walking belt still slows when walked on, see the front cover of this manual.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Contact the Store Where YOU Purchased this Product QUESTIONS?Table of Contents Important Precautions Save These InstructionsBefore YOU Begin Assembly Make sure that the power cord is unpluggedPage Operation and Adjustment HOW to Plug in the Power CordConsole Diagram Features of the ConsoleSelect the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Insert the key into the consoleFollow your progress with the display Measure your heart rate if desiredHOW to USE a Preset Workout HOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USEProblem The walking belt slows when walked on TroubleshootingProblem The power turns off during use Compatible with GFCI-equipped outletsPlatform. Avoid pinching your fingers Problem SolutionLubricating the Walking Belt Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart LIST-Model No. WLTL14709.0 Key No. Qty DescriptionExploded Drawing A-Model No. WLTL14709.0 Exploded Drawing B-Model No. WLTL14709.0 R0110A Ordering Replacement Parts
Top Page Image Contents