10. Lower the Uprights (31, 36) as shown. | 10 |
| Side View |
| 32 | |
See the inset drawing. Position the Uprights |
|
| ||||
(31, 36) so that the treadmill Frame (74) is cen- |
|
|
|
|
| 40 |
tered between the Uprights. |
|
|
| 31, 36 |
| |
Firmly tighten the Frame Bolts (32) and then the |
|
|
|
| ||
Upright Bolts (40) on each side of the treadmill. |
|
| 74 |
|
|
|
Do not overtighten the Frame Bolts. |
|
|
|
|
| |
| 31 |
| View from Above | 36 | ||
|
|
| 74 |
| ||
11. Attach the ground wire on the Upright Wire (28) | 11 |
| Grommet |
|
| |
to the indicated hole in the Base (48) with a |
| 36 |
| |||
Silver Ground Screw (27). |
|
|
| 28 |
| |
Press the indicated grommet into the Right |
| 48 |
|
|
| |
|
|
|
|
| ||
Upright (36). |
|
|
|
|
| |
Raise the Uprights (31, 36). |
|
|
|
|
|
|
| Hole |
|
|
| Ground |
|
|
| Wire | 27 |
|
|
|
| |
12. Attach the Latch Housing (30) to the Left Upright | 12 |
|
|
(31) with two 3/4" Screws (2). Make sure that |
|
| |
the large hole in the Latch Housing is on the |
| 30 | 31 |
side shown. Do not overtighten the Screws. | Knob | ||
Remove the knob from the pin. Make sure that |
| Large | |
the collar and the spring are on the pin as |
|
| |
shown. Insert the pin into the Latch Housing | 2 |
| Hole |
(30), and tighten the knob back onto the pin. |
| Pin | |
| Spring |
| |
| Collar |
|
|
13. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; the large hex key is used to adjust the walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.
10