Weslo WCTL31304.0 user manual Console Diagram, STEP-BY-STEP Console Operation

Page 11

CONSOLE DIAGRAM

Note: If there is a thin sheet of plastic on the console, remove it.

CAUTION: Before operating the console, read the following precautions.

Do not stand on the walking belt when turn- ing on the power.

Always wear the clip (see the drawing below) while operating the treadmill.

Adjust the speed in small increments to avoid sudden jumps in speed.

To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and place only a sealed water bottle in the water bottle holder.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in (see page 10).

Stand on the foot rails of

 

the treadmill. Find the clip

 

attached to the key (see

 

the drawing), and slide the

 

clip onto the waistband of

 

your clothes. Next, insert

Key

the key into the console.

Clip

After a moment, the dis-

 

plays will light. Test the

 

clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip.

Follow the steps below to operate the console.

1 Insert the key into the console.

A moment after the key is inserted, the displays will light.

Press the Start button or the Speed increase

2 button to start the walking belt.

A moment after the button is pressed, the walking belt will begin to move. Hold the handrails and begin walking.

As you exercise, change the speed of the walking belt as desired by pressing the Speed buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph. Note: The console can display speed and distance in either miles or kilometers (see SPEED DISPLAY on page 12). For simplicity, all instructions in this section refer to miles.

To stop the walking belt, press the Stop button. The elapsed time will begin to flash in the Time display.

Note: During the first few minutes that the treadmill is used, inspect the alignment of the walking belt, and align it if necessary (see page 16).

11

Image 11
Contents Model No. WCTL31304.0 Serial No QUESTIONS?Table of Contents Important Precautions Page Back Before YOU BeginRight Side Treadmill until it is completely assembled AssemblyMake sure that the power cord is not plugged Your own Phillips screwdriver Needlenose pliersPage Top View Page PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Insert the key into the console Console DiagramSTEP-BY-STEP Console Operation Follow your progress with the four displays When you are finished exercising, removeChange the incline of the treadmill as desired Measure your heart rate if desiredHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE View TroubleshootingProblem The power turns off during use TopProblem The walking belt slows when walked on Exercise Frequency Conditioning GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Page Limited Warranty HOW to Order Replacement PartsKey Qty Description R0705AExploded Drawing Exploded Drawing B-Model No. WCTL31304.0 R0705A Exploded Drawing C-Model No. WCTL31304.0 R0705A