Weslo WETL01540 Maintenance and Troubleshooting, Symptom the Console does not Function Properly

Page 8

MAINTENANCE AND TROUBLESHOOTING

Most problems can be solved by following the simple steps below. If further assistance is needed, please call our Customer Service Department.

1.SYMPTOM: THE CONSOLE DOES NOT FUNCTION PROPERLY

a.Replace the batteries in the console (see assem- bly step 6 on page 5).

b.Make sure that the reed switch is properly adjust- ed (see assembly step 4 on page 4).

c.Make sure that the handrail wire is plugged fully into the wire on the console (see assembly step 7 on page 5).

d.The console, like most electronics, is susceptible to static electricity build-up caused by certain types of clothing or by the operation of the tread- mill. If the display is blank or gives incorrect read- ings, apply an anti-static spray to the handrail. Anti-static spray is available where laundry sup- plies are sold.

2.SYMPTOM: THE WALKING BELT DOES NOT MOVE SMOOTHLY

a.If the walk-

ing belt is

Walking

overtight-

Belt

ened, per-

 

formance

 

may be

 

reduced and

 

the walking

 

belt may be

 

permanently

5–7cm

damaged.

Bolts

 

Using the

 

hex key,

 

turn both rear roller adjustment bolts counter- clockwise 1/4 of a turn. When the tension of the walking belt is correct, you should be able to lift each side of the walking belt 5 to 7 cm (2 to 3 in.). Walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened. Be careful to keep the walking belt centred.

3.SYMPTOM: THE WALKING BELT SLIPS OR IS OFF-CENTRE

a. If the walking belt slips when walked

on, use the hex key to turn both adjust- ment bolts clockwise, 1/4

of a turn. When

the walking belt is correctly tightened, you should be able to lift each side of the walking belt 5 to 7 cm (2 to 3 in.). Walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened. Be careful to keep the walking belt cen- tred.

b. If the walking belt has shift- ed to the left

side, use the hex key to turn the left adjust- ment bolt clockwise, and

the right adjust-

ment bolt counterclockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the treadmill for a few minutes. Repeat until the walking belt is centred.

c. If the walking belt has shift- ed to the right

side, use the hex key to turn the left adjust- ment bolt coun- terclockwise,

and the right

adjustment bolt clockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the treadmill for a few minutes. Repeat until the walking belt is centred.

8

Image 8
Contents Model No. WETL01540 Serial No QUESTIONS?8457 089 Table of Contents Important PrecautionsBefore YOU Begin Assembly Included hex key and wrenchView from BeneathPage STEP-BY-STEP Console Operation Treadmill OperationLubricating the Walking Platform Lowering the Treadmill for USE Incline AdjustmentFolding the Treadmill for Storage Maintenance and Troubleshooting Symptom the Console does not Function ProperlySymptom the Walking Belt does not Move Smoothly Symptom the Walking Belt Slips or is OFF-CENTREWHY EXERCISE? HOW to Measure Your Heart RateConditioning Guidelines Exercise IntensityQty Description Part LIST-Model No. WETL01540Exercise Frequency Exploded DRAWING-Model No. WETL01540 R1004AOrdering Replacement Parts 08457 089