6.Set the Console (1) on the Right Handrail (6) and the Left Handrail (not shown). Start four Console Screws (58) (only two are shown) into the Console. After you have started all four Console Screws, tighten them.
Insert the excess Wire Harness (22) down into the Right Handrail (6). Tighten the three plastic ties around the Wire Harness, and then cut off the ends of the plastic ties.
7.Attach the Console Back (4) to the Console (1) with four Console Screws (58). Make sure that no wires are pinched.
See step 4. Tighten the four Handrail Bolts (12).
8.Raise the Frame to the vertical position (55). Make sure that the Latch Pin (69) is in the Storage Latch (41) as shown. Attach the Storage Latch to the Frame (55) with three Latch Screws (70). Do not tighten the Screws yet.
See the inset drawing. Position the Storage Latch (69) so the Latch Pin (69) is aligned with the hole in the Left Handrail (7). Slide the Latch Pin into the hole, as shown.
Tighten the three Latch Screws (70).
6 | 1 |
| |
| 22 |
| Plastic |
58 | Ties |
| 6 |
7 | 1 |
|
|
|
| 58 |
| 58 |
|
|
|
| 4 |
|
|
| 58 |
|
8 |
|
|
|
| 55 |
|
|
| 41 |
|
|
70 | 69 | 41 | 69 |
| |||
|
|
| |
|
| Hole |
|
|
| 7 |
|
9.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill.
7