12.Attach the Latch Housing (85) to the Left Upright (86) with two #10 x 1" Tek Screws (7). Make sure that the Latch Housing is oriented as shown.
Locate the Latch Pin Assembly (84). Remove the knob from the pin. Make sure that the collar and the spring are on the pin as shown. Insert the pin into the Latch Housing (85), and tighten the knob back onto the pin.
13.Attach each Incline Leg (63) to the Frame (61) with an M8 x 52mm Bolt (8), two M8 Washers (10), and an M8 Nut (16).
12 |
|
|
|
|
|
| |
| 84 | 85 |
|
| 86 |
| |
| Knob |
|
|
| Spring |
| |
| 7 |
|
|
| Collar | ||
| Large Hole |
|
| Pin |
| ||
13 | 61 |
|
|
|
|
| |
8 | 10 | 16 | 63 | 10 | 8 | ||
63 | |||||||
| 10 |
|
| 10 |
|
| |
|
|
|
|
|
| ||
14.Insert the Incline Pins (62) at the desired incline level (see HOW TO CHANGE THE INCLINE OF THE TREADMILL on page 17).
14
62 | 62 |
15.Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys in a secure place. The large hex key is used to adjust the walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.
12