Weslo 831.29522.0 user manual Connector is not Inserted Properly, Console MAY be Damaged When

3. If there is a plastic tie in the right Upright (46), remove

the plastic tie.

Hold one of the Handrails (59) near the right Upright (46)

as shown. Insert the Wire Harness (60) up through the

hole in the bottom of the Handrail and out of the round

hole in the side of the Handrail. If necessary, use

needlenose pliers to pull the Wire Harness out of the

hole. Be careful not to damage the Wire Harness.

Set the Handrail (59) on the upper end of the right

Upright (46). Tighten a Handrail Bolt (55) into the right

Handrail and the Upright as shown. Be careful not to

pinch the Wire Harness (60).

Attach the other Handrail (59) as described above. Note:

There are no wires on the left side.

4. Set the Console Base (52) on the Handrails (59). Thread

four 3/4” Screws (2) into the Handrails and the Console

Base. After you have started all four Screws, tighten the

Screws until they are snug; do not overtighten the

Screws. Note: It may be helpful to press down on the

top of the Console Base above the Handrails as you

tighten the Screws.

Insert the Wire Harness (60) through the two indicated

plastic ties on the Console Base (52) and up through the

hole in the Console Base as shown.

5. Hold the Console (65) near the Console Base (52).

Touch the right Handrail (59) to discharge any static.

Insert the Wire Harness (60) through the plastic tie

labeled C in the drawing at the right. Next, locate the

connector on the Wire Harness. Plug the Wire Harness

3
55
	59
	60	59
	55
	46
		46
4
	52
60
59
2	Plastic Ties	2
5	65
	A
	Tie C

into the connector labeled A in the drawing at the right

and in the inset drawing. The connectors should slide

together easily and snap into place. If they do not,

turn the connector on the Wire Harness and try again. IF

THE CONNECTOR IS NOT INSERTED PROPERLY,

THE CONSOLE MAY BE DAMAGED WHEN THE

POWER IS TURNED ON.

Pull any slack in the Wire Harness (60) through the plas-

tic tie labeled C, and securely tighten the plastic tie

around the Wire Harness. Cut off the end of the plastic

tie.

7

59

52 60

A 60