-Calculate from the determined magnetic azimuth Am of the reference point and the target to find the directional angles, reckoning in the compass correction ∆ A obtained from the formula:
α= Am – ∆ Am
Read the compass correction ∆ Am of the map;
-Note down the reference point target directional angles on the plotting board of card;
-Mark numbers of the plotting board with respect to the selected scale (1:25, 000 or 1:50,000) and the reference point, observation post and target location;
-Read the rectangular coordinates of the reference point from the map and note them down on the plotting board or card;
-Align the circular scale zero of the plotting board with vernier zero;
-Use the reference grid of the plotting board to plot the reference point on the circular scale in accordance with the map coordinates;
-Set the circular scale of the board to read the directional angle as determined for the reference point from the observation post;
-Draw a vertical line from top downwards through the reference point marked on the circular scale. See that the line is parallel with the grid lines;
-Use the rule to lay off the
-Adjust the circular to read the directional angle as determined for the target from observation post;
-Pass a vertical line from bottom upward through the OP point in parallel with the grid lines on the circular scale;
-Use the rule to lay off the OP-
-Setting the circular scale to zero, read the target and OP rectangular coordinates off the board. Note down the coordinates on the board or card;
-Plot the target on the map using the obtained rectangular coordinates.
8.9.When using the range finder under the conditions of insufficient light set the ILLUM. Selector switches to ON the range finder.
8.10.A necessity may arise to range a target located against an intense background (bright sky, sunlit snow or sand, etc.) In this case, the left- hand eyepiece may indicate as if more than one target is caught in the beam, and the range indications may differ every time that MEASURE L button is depressed. To eliminate the adverse back ground effects, the frame of the Binocular objective should be fitted with the diaphragm 22 (Fig. 6) secured by means of a pin and rubber clamp on the case over.
The diaphragm is not to be used at critical subzero temperature, in mist and limited visibility conditions.