11.2. The problems likely to occur in the range finder are |
| |||||||
listed with their causes and remedies below in | Table 11.1 |
| ||||||
|
|
|
|
|
|
| Table 11.1 | |
|
|
|
|
|
| |||
Possible problems | Probable cause |
|
| Remedy |
| |||
|
|
|
| |||||
1. Picture blurred | Condensed | moisture, | Clean exterior of optical | |||||
in | dirt | on | external | parts | as directed under | |||
eyepiece | optical |
|
| surfaces | 11.6.2 |
|
| |
| Condensed | moisture | Dry | range finder | as | |||
| on internal | optical | directed under 11.6.3 |
| ||||
| surfaces |
|
|
| Clean | contacts | as | |
2. Readiness indica- | Open |
| circuit | in | ||||
tor remains dark | battery section (when | directed under 11.6.1 |
| |||||
after depressure of | standard | battery | is |
|
|
| ||
MEASURE 1 | used) |
|
|
|
| Replace fuse as directed | ||
(MEASURE L) | Blown |
| fuse | in | ||||
button | protection | device | under 12.3.1 |
| ||||
| when |
|
| vehicle |
|
|
| |
| electrical | system | is |
|
|
| ||
| used |
|
|
|
| Clean | contacts | as |
| Open |
| circuit | in | ||||
| battery | section when | directed under 11.6.1 |
| ||||
| vehicle |
|
| electrical |
|
|
| |
| system is used |
| Replace the battery with | |||||
3. Red glow is obser- | Unallowably |
| low | |||||
ved in indicator | battery voltage |
| a newly charged one as | |||||
eyepiece |
|
|
|
|
| directed under 12.3.2 |
| |
|
|
|
|
|
|
|
|
|
11.3.To correct problems by using the individual SPTA set proceed as follows (see Fig. 6).
11.3.1.To replace the fuse link 2 in the protection device:
- Unscrew the threaded cover from the housing of the protection device;
- Remove the defective fuse link;
- Insert the spare fuse link from the SPTA set;
- Screw the cover on the housing of the protection device.
11.3.2.To replace the rechargeable battery 1: - Open the cover of the battery section;
- Remove the used battery;
- Fit the new battery in the section so that the "+" terminal of the battery is connected with the bottom contact of the section;
- Close the cover of the battery section.
11.3.3.To replace the fuse link in the charging device: - Unscrew the outer threaded covers from the fuses;
- Unscrew the bayonet of the fuse link holders; - Remove the fuse links;
- Fit in good fuse links;
- Close the holder covers;
- Screw on the outer threaded covers.
11.3.4.The individual SPTA set includes the following tools and accessories:
- Charging device 11, operated to charge Rechargeable battery