Hobie manual Hobie Float Cat Stripping Apron Assembly

Hobie Float Cat

Stripping Apron Assembly

(SEE ALSO: Large Diagrams Pg. 4)

Stripping Apron Parts List

Frame Rods:

J-1 fiberglass rod with hinge and ferrule

J-2 fiberglass rod with hinge and plain tip

Apron:
K-1	nylon storage bag with plastic hook and mesh
K-2	nylon storage bag with D ring	K1
L	two 7” aluminum apron support posts with molded

plastic C clamps

Hardware:

K2

Mfour clevis pins with split rings

N two washers

O two eyebolts with nuts J1 J2

Ptwo Phillips head screws

Q two metal apron clips

Required tools: One large slot head screwdriver, one medium Phillips head screw driver

NOTE: Right and left references assumes a seated position facing aft.

Stripping Apron Assembly Instructions

STEP 1- Insert eyebolts (O) from outside seatback, through white

nylon bushings located on either side of seatback. Secure each with nuts. Eyebolts will spin freely in bushings.

STEP 2- Locate K1 and K2 and separate by undoing all Velcro edges and unhooking black plastic hook on K1 from D ring on K2.

STEP 3- With Velcro edges completely unattached and bag facing zipper up, grasp K1 by grommeted tab and insert ferrule end of J1 into the webbing sleeve along the curved edge of K1, bending rod as needed. Slide rod through sleeve until grommeted tab can be inserted into hinge and lined up with the first hole (hole A) of hinge. Secure with clevis pin and split ring. Repeat procedure with K2 and J2.

(SEE ALSO: Large Diagrams Pg. 4)

2