MANGO
El Cepillo de combinacion puede ser almacenado en el mango de la manguera, colocandolo en el mango antes de conectar el tubo telescopico. Desliza el cepillo de combinación firmemente dentro del mango.
Mango 
Cepillo para combinación
Introduzca el tubo en el mango hasta que el botón quede en posición. Asegúrese de que la manguera no esté torcida.
Para retirar: Oprima el botón de liberación rápida del mango para liberar el mango y tire del mango hacia arriba.
Para Guardar: Para prevenir la presión de la manguera mientras se guarda, desuna la manguera del tubo de la aspiradora. Guarde la manguera en una posición enrollada y floja de tal manera que la tapa de la manguera no se estire.
| Botón de |
Botón de | liberación |
del tubo |
liberación
del cepillo
Cepillo para combinación
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency high and to prevent damage to your vacuum cleaner, the agitator must be cleaned every time the belt is changed.
The agitator must also be cleaned according to the following schedule:
Vacuum Cleaner Use | Clean Agitator |
HEAVY - | every week |
(used daily) |
|
MODERATE - | every month |
(used |
|
LIGHT - | every 2 months |
(used 1 time/week) |
|
IMPORTANT
Disconnect vacuum cleaner from electrical outlet. Check and remove hair, string and lint
Remove any dirt or debris in the belt path area or in the brush roller area.
Carefully remove any string or debris located on the agitator or end caps.
AGITATOR ASSEMBLY | ||
End Cap |
| Belt Path |
|
| |
| Brush Unit | End Cap |
|
| |
TO REPLACE BELT
NOTE: Use replacement belt STYLE
1. Install new |
|
|
belt over | Motor |
|
motor drive, | Drive |
|
then over |
|
|
belt path. | Belt Path |
|
Agitator | End Cap | ENGLISH |
| 2. Place agitator | |
| assembly into |
|
| PowerMate . |
|
3.NOTE: Be sure that the dirt sensor board is positioned in slots and all wiring is tucked back in place.
4.Line up front of cover and base. Rest cover on front edge of base as shown.
5.Rotate cover 
back. Press cover firmly until side latches snap into place.
6.Make sure there is no gap between the cover and base and that the rear latches are snapped in place.
7.Turn PowerMate upside down and replace four (4) cover screws.
8 | 25 |
