Sears 831.29788 Scissors, Driver ,,===E Adjustable, Extension Leg Screw Handrail Washer

ASSEMBLY

..•

Assembly requires two people. Set the treadmill in a cleared area and remc>veall packing materials. Do not dispose of the packing materials until assembly is completed. Refer to the drawings below .t.oidentify the small

			the included• allen wrench¢h_ and your own i_hillips screw-
parts used in assembly. Assembly		requires	_	,	and scissors _.
driver ,,==_=E:_),	adjustable	wrench			_..	._ .

	h			1/2" Screw (13)-2. -
		....	"Extension Leg Screw (34)-2
Handrail Washer (16)-4		_\	Handrai! B°RL.n©_(15	3/4" Screw (91)@"-4
	Flange Nut (57)-2

3 1/2" Handrail Bolt (89)-2

3/8" Washer (61)-2

. W'dhthe help of a second person, carefully lay the	1
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (41) into the treadmill. Make
sure that the Extension Legs are turned so the Base
Pads (36) are on the indicated side. Attach each
Extension Leg with an Extension Leg Screw (34).
With the help of a second person, carefully raise the
treadmill to the upright position so the Extension Legs
(41) are resting flat on the floor.
	..°

oRefer to HOW TO LOWER THE TREADMILL FOR USE

on page 13. Follow the instructions to lower the treadmill.

2

Position the Left Handrail (2) on the left Upright (14). The lower end of the Left Handrail should be on the Outside of

the Extension Leg (41) as shown. Thread a Handrail Bolt

(15)with a HandrailWasher (16) into the left Upright and the Left Handrail. Do not.tighten the Handrail Bolt yet.

Attach the lower endof the Left Handrail (2) to the

Extension Leg (41) with a 3 1/2"Handrail Bolt (89), a 3/8" Washer (61), and a.Flange Nut (57). Do not tighten the Handrai!_.Bolt yeL

5