PPt£RFM- ThPwalking belt slows when walked on

PPt£)R[FM_- ThP_walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that is UL 1449 listed as a transient voltage surge sup-

pressor (TVSS). The surge suppressor must have a UL suppCessed voltage rating of 400 volts or less and a minimum surge dissipation of 450 joules. The surge suppressor must be electrically

rated for 120 volts AC and 15 amps.

...r

b.if the walking beit is overtightened, treadmill perforo

-_-rnancemay decreaseand the .walking belt may be- pern_anently damaged. Remove the key and UN- PLUG THE POWER CORD. Using the allen wrench, turn both rear roller adjustment bolts counterclock- wise, i/4 of a.tum..When the walking belt is properly tightened, you should be able to lift each side of the walking belt 3 to 4 inches offthe walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

c. If the walking belt still Slows when walked on, please call our toll-free HELPLINE.

PROBLEM: The walking belt is off-center when walked on

SOLUTION: a. If the walking belt has shifted to the left, first remove the key and UNPLUG THE POWERCORD. Using the allen wrench, turn the left rear roller adjustment bolt clockwise, and the right bolt countemlockwise, 1/4 of a turn each. Be careful not to overtighten the walking be_ Plug in the power cord, insert the key and run the treadmill fora few minutes. Repeat until. the walking belt is centered.

b. If the walking belt has shifted to the right, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn the left rear roller adjustment bolt counterclockwise, and the right bolt clockwise, 1/4 of a turn each. Be careful not to overtighten the

walking belt. Plug in the power cord, insert the key . and run the treadmill for a few minutes. Repeat until

the walking beltis centered. -

PROBLEM: The walking belt slips when walked on

SOLUTION: a. If the walking belt slips when walked on, first remove

tl_e key and UNPLUGTHE POWERCORD. Using- the allen wrench, turn both rear roller adjustment bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each side of the walking belt 3 to 4 inchesoff the walking platform. Becareful to keep the walking belt centered Plug in the power cord, insert the key and run-thetreat:lmillfor a few minutes. Repeat until the walking belt is properly tightened.