HARDWARE IDENTIFICATION CHART
This chart is provided to help identify the hardware used in the assembly process. Place the washers or the ends of the bolts or screws on the circles to check for the correct diameter. Use the small scale to check the length of the bolts and screws.
| 3/16" |
| 1/4" | 5/16" | 3/8" |
| 1/2" |
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| INCHES |
|
|
| |
0 | 1/2 |
| 1 | 1/2 | 2 | 1/2 | 3 |
| 1/2 | 4 | 1/2 | 5 | 1/2 | 6 | |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| in. |
0 | 10 | 20 | 30 | 40 | 50 | 60 | 70 | 80 | 90 | 100 | 110 | 120 | 130 | 140 | mm. |
150 | |||||||||||||||
|
|
|
|
|
|
|
|
| MILLIMETERS |
| length | ||||
| 6 |
| 8 |
| 10 |
| 12 |
|
|
|
|
|
|
|
|
NOTICE: The length of all bolts and screws, except those with flat heads, is measured from below the head to the end of the bolt or screw. Flat head bolts and screws are measured from the top of the head to the end of the bolt or screw.
length 
After unpacking the unit, open the hardware bag and make sure that you have all the following items. Some hardware may be already attached to the part.
Part No. and Description | Qty | |
24 | Plastic Wheel | 2 |
25 | Rubber Foot | 4 |
37 | Screw, Round Head (M5 x 0.8 x 35mm) | 4 |
40 | Nylock Nut (M8 x 1.25) | 2 |
46 | Washer (M8) | 6 |
49 | Locking Knob | 2 |
| 6 |
|