SET UP Instructions

Place the TOTAL BODY RECUMBENT BIKE in the area where it will be used. It is recommended that the TOTAL BODY RECUMBENT BIKE be placed on an equipment mat. The TOTAL BODY RECUMBENT BIKE is approximately 49 5/8" long x 23 5/8" wide x 48 5/8" tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 6 feet long is required for safe operation of the TOTAL BODY RECUMBENT BIKE. Make sure that adequate space is available for access to and passage around the TOTAL BODY

RECUMBENT BIKE.

LEVELING: Place the TOTAL BODY RECUMBENT BIKE on a flat surface and equipment mat to set it on the floor without rocking. Adjust the STAND(65) under the REAR FRAME(2) to get more support for the base of the TOTAL BODY RECUMBENT BIKE.

MOVING: The TOTAL BODY RECUMBENT BIKE has a pair of WHEELS(76) on the FRONT STABILIZER(8). Lift up from REAR STABILIZER(9) to move the TOTAL BODY RECUMBENT

BIKE.

Equipment Mat

Nut

Loosen the NUT(M8x1.25) until they touch the LEVELING STAND(65). Adjust the LEVELING STAND(65) for leveling. Tighten the NUT (M8x1.25) securely against the REAR FRAME(2) to lock the stand in position.

FUNCTION INSPECTION:

Visually inspect the TOTAL BODY RECUMBENT BIKE to verify that assembly is as shown in the above illustration. Check the function of the TOTAL BODY RECUMBENT BIKE. Turn the pedal and then handlebar slowly through one complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(21) and verify that it functions properly.

CAUTION: Locate and read the WARNING LABEL(108) on the TOTAL BODY RECUMBENT BIKE. Make sure that all users read the WARNING LABEL(108).