OPERATIONAL INSTRUCTIONS
ADDING A FITNESS MONITOR OR METER
The CPS 9200 Indoor Cycle does not include a fitness monitor or meter, but is equipped to add a fitness monitor or meter if you wish. Fitness monitors can be purchased at stores that sell biking accessories. Purchase a meter that can be attached to the HANDLEBAR(2), and follow any installation and operation instructions provided by the manufacturer. Your CPS 9200 Indoor Cycle comes equipped with MAGNET(73) built into the FLYWHEEL (23), so it is not necessary to install the magnet that comes with your meter; just attach the sensor to the SENSOR CLIP(74) on the MAIN FRAME(1) and attach the meter to the HANDLEBAR(2) following manufacturers instructions.
NOTE: Some models of fitness monitors/meters may not attach to the SENSOR CLIP(74). In this case, attach the sensor to the MAIN FRAME(1) using the sensor bracket provided by the manufacturer.
MONITOR/METER
(not included)
SENSOR 
(Round bar type)
STORAGE
1.To store the CPS 9200 Indoor Cycle, simply keep it in a clean dry place.
2.Adjust the HANDLEBAR(2) and the SEAT POST(5) to the lowest position. Adjust the SEAT SLIDER(6) to the most forward position. The CPS 9200 Indoor Cycle is approximately 40 3/4 inches long (min.) x 18 3/8 inches wide x 37 1/4 inches tall (min.). These dimensions will vary. Please measure your CPS 9200 Indoor Cycle if exact dimensions are needed.
3.To move the CPS 9200 Indoor Cycle, lift the REAR STABILIZER(4) and use the WHEELS(49) on the
FRONT STABILIZER(3).
MAINTENANCE
The safety and integrity designed into the CPS 9200 Indoor Cycle can only be maintained when the CPS 9200 Indoor Cycle is regularly examined for damage and wear. Special attention should be given to the following:
1.Adjust the TENSION KNOB(34) and verify that the Flywheel System provides tension. The Flywheel System should provide many years of use.
2.Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the left pedal has left hand threads and is tightened by turning counterclockwise. The right pedal has right hand threads that are tightened by turning clockwise.
3.Verify that the WARNING LABEL(70) is in place and easy to read. Call Stamina Products immediately at
4.It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
5.Worn or damaged components shall be replaced immediately or the CPS 9200 Indoor Cycle removed from service until repair is made.
6.Only Stamina Products supplied components shall be used to maintain/repair the CPS 9200 Indoor
Cycle.
7.Keep your CPS 9200 Indoor Cycle clean by wiping it off with an absorbent cloth after use.
13