SET UP INSTRUCTIONS
Place the CPS 9200 Indoor Cycle in the area where it will be used. It is recommended that the CPS 9200 Indoor Cycle be placed on an equipment mat. The CPS 9200 Indoor Cycle is approximately 50 inches long (max.) x 18 3/8 inches wide x 42 5/8 inches tall (max.). An area 4 feet wide x 6 feet long is required for safe operation of the CPS 9200 Indoor Cycle. Make sure that adequate space is available for access to and passage around the CPS 9200 Indoor Cycle.
LEVELING: Adjust the STANDS(51) under the FRONT and REAR STABILIZER(3, 4) so that the CPS 9200 Indoor Cycle sits on the floor without rocking. Refer to the instructions below the illustration.
MOVING: The CPS 9200 Indoor Cycle has a pair of WHEELS(49) on the FRONT STABILIZER(3). Lift up the REAR STABILIZER(4) to move the CPS 9200 Indoor Cycle.
EQUIPMENT MAT
(not included)
Loosen the NUTS(M8x1.25)(67) until they touch the STANDS(51). Adjust the STANDS(51) for leveling. Tighten the NUTS(M8x1.25)(67) securely against the STABILIZERS(3, 4) to lock the STANDS(51) in position.
FUNCTION INSPECTION:
Visually inspect the CPS 9200 Indoor Cycle to verify that assembly is as shown in the above illustration. Check the function of the CPS 9200 Indoor Cycle by turning the crank slowly through one complete revolution to verify that the drive train functions properly. Adjust the TENSION KNOB(34) to verify that the adjustable tension is working properly.
CAUTION: Locate and read the WARNING LABEL(70) on the CPS 9200 Indoor Cycle. Make sure that all users read the WARNING LABEL(70).
10