Sears 831.24843.0 user manual Symptom The upperbody arms squeak during use

Page 22

SYMPTOM: The walking belt is off-center or slips when walked on

a.If the walking belt is off-center, first remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left idler roller screw clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the left idler roller screw counterclock- wise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.

a

b.If the walking belt slips when walked on, first re- move the key and UNPLUG THE POWER CORD.

Using the hex key, turn both idler roller screws clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walk- ing belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

b

SYMPTOM: The upperbody arms squeak during use

a.(Note: Correcting this problem requires a small amount of marine grease, available at hardware stores.) Turn the resistance knob (A) counterclock- wise and remove it. Next, remove the resistance cone (B) and the upper body arm (C), along with the resistance plate (D), plastic spacer (E), spring washer (F), washers (G), and thrust bearing (H). (Note: If the resistance plate [D] comes out of the resistance cone (B), press it back in.) Apply a thin layer of white marine grease to the outer surface of the resistance cone (B). Then reattach all parts in the order shown below.

C

B

E

G

D F H A

22

Page 21 Page 23
Image 22
Page 21 Page 23
Contents Treadmill Exerciser Model No Serial NoTable of Contents Important Precautions Page Before YOU Begin Part Identification Chart Make sure that the power cord is unplugged AssemblyAge the Upright Wire Be careful not to pinch the Upright Wire See the inset drawing. Tie the wire tieTighten the Screws yet Attach the Left Upright not shown Upright Wire 63. Start both Screws, and then tighten them Start all four Screws, and then tighten themPage Page Page Operation AND ADJUSTMENT HOW to Plug in the Power CordConsole Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeLower right dis- play-The lower right Upper Display-The upper displaySelect a preset workout HOW to USE a Preset WorkoutFollow your progress with the displays Information Mode HOW to USE the Crosswalk ArmsHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill HOW to Lower the Treadmill for USESymptom The power does not turn on TroubleshootingSymptom The power turns off during use Symptom The walking belt slows when walked on Symptom The upperbody arms squeak during use Workout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart List Key No. Qty DescriptionExploded Drawing a Exploded Drawing B Exploded Drawing C DAY Full Warranty Sears, Roebuck and Co., Hoffman Estates, IL
Top Page Image Contents