HOW TO TURN ON THE POWER | 3. Start the walking belt. |
iMPORTANT: if the treadmill has been exposed to cold temperatures, allow it to warm to room tern= perature before turning on the power, if you do not do this, the console displays or other electrical
components may become damaged.
Plug in the power cord (see
page 12). Next, locate the
reset/off circuit breaker on Position
the treadmill frame near the Reset
power cord. Switch the cir- cuit breaker to the reset po- sition.
iMPORTANT: The console features a display demo mode, designed to be used if the treadmill is dis= played in a store, if the displays light as soon as you plug in the power cord and switch the circuit breaker to the reset position, the demo mode is turned on. To turn off the demo mode, hold down the Stop button for a few seconds, if the displays
remain lit, see THE iNFORMATION MODE on page 17 to turn off the demo mode.
Next, stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing on page 13) and slide the clip onto the waistband of your clothes. Then, insert the key into the console. After a moment, the displays will light. IMPORTANT: In an emergency situation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully taking a few steps backward; if the key is not pulled from the console, adjust the posi= tion of the clip.
HOW TO USE THE MANUAL MODE
1.insert the key into the console.
See HOW TO TURN ON THE POWER on page 13.
2.Select the manual mode.
When the key is in- | ||
serted, the manual |
| |
mode will be selected. If | U'UU | |
you have selected | a |
|
speed workout, reselect |
| |
the manual mode | by |
|
pressing the Workouts button repeatedly until only zeros appear in the displays.
To start the walking belt, press the Start button, the Speed increase button, or one of the numbered speed buttons.
If you press the Start button or the Speed increase button, the walking belt will begin to move at 1 mph. As you exercise, change the speed of the walking belt as desired by pressing the Speed increase and decrease buttons. Each time you press a but- ton, the speed setting will change by 0.1 mph; if you hold down a button, the speed setting will change in increments of 0.5 mph. Note: After you press the buttons, it may take a moment for the walk- ing belt to reach the selected speed setting.
If one of the numbered speed buttons is pressed, the walking belt will gradually change speed until it reaches the selected speed setting.
To stop the walking belt, press the Stop button. The time will begin to flash in one of the displays. To restart the walking belt, press the Start button or the Speed increase button.
4.Change the incline of the treadmill as desired.
To change the incline of
the treadmill, press the
Incline increase and de---
crease buttons. Each time you press one of the buttons, the incline will
gradually increase or decrease until it reaches the selected incline setting.
. Follow your progress with the track and the dis=
plays.
The
pear in succession until the entire track appears. The track will then disappear and the indicators will again begin to appear in succession.
14