2.Have a second person hold the Base (52) in the position shown.
Identify the Left Upright (53) (the Right Upright [54] has a large hole near the lower end).
Hold the Left Upright (53) so the two small holes for the latch assembly are on top as shown. Attach the Left Upright to the Base (52) with two M10 x 75mm Bolts (2) and two Mt0 Star Washers (9). Do not tighten the Bolts yet.
Attach the Right Upright (54) to the Base (52) in the same way.
3.Attach each Extension Leg (45) to the Base (52) with two M8 x 58mm Bolts (13), two M8.5 Washers (32), and two Extension Leg Nuts (43). Note: The heads of the wheel bolts should be on outside of the Extension Legs.
Lower the Base (52) so that it is flat on the floor.
Position the Base (52) as close to the front of the treadmill as possible, as shown.
See the upper inset drawing. Locate the wire tie in the lower end of the Right Upright (54). Tie the wire tie securely around the end of the Wire Harness (39). Then, locate the other end of the wire tie in the upper end of the Right Upright. Pull the upper end of the wire tie until the Wire Harness is extending from the upper end of the Right Upright. Secure the Wire Harness to the Right Upright so that it will not fall inside.
See the lower inset drawing. Press the indi- cated Grommet (49) into the Right Upright (54).
2
Small Holes
53
Bolt
32
54
Hole
52
9
13"
32
52
39
54
39