Coleman 17'X9 Raise Ends of Tent, Raise Center of Tent, Made in China, Things You Should Know

3 Raise Center of Tent

– Assemble center shock-corded brace poles (red sticker, longer poles).

Pole should be initially adjusted to the inner most hole “A”. (illus. 7)

– Insert square end of brace poles into

Brace pole

Curved

poles in

pole sleeve

illus. 6 When attaching the brace poles to the curved poles make sure that the brace poles naturally point straight down.

curved roof poles and raise tent upright. (illus. 5, 6, 7)

– Brace poles should attach to squeeze pins at bottom of tent. (illus 8)

– Repeat for brace poles at front of screen area.

illus. 5

Shown with both center brace poles in

position and curved poles through

center pole sleeves.

illus. 7

Poles should be initially adjusted to the inner most hole “A”.

4 Raise Ends of Tent

– Assemble end (blue sticker, round ends) shock-corded brace poles.

– Insert (blue sticker) brace poles into end roof assemblies. MAKE SURE when attaching the brace poles to the curved poles that the bottom of the brace pole naturally points down and toward the center of the tent. (illus. 9)

– Brace poles should attach to squeeze pins at bottom of tent. (illus. 8)

– Adjust poles to accomodate for terrain.

Center brace poles

Rainfly hooks to brace poles

illus. 8

Insert squeeze pin into pole

– Drape narrower end of rainfly over tent- wider end over screen room, covering the center and end poles sleeves. Attach “S” hooks on rainfly into holes in brace poles. (illus. 9)

Stake down

doormat illus. 9 Tent shown completely set-up. Note the different angles of the end brace poles.

Things You Should Know

•Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

•TENT POLES SHOULD NOT BE LEFT TELESCOPED TOGETHER DURING STORAGE.

PRINTED IN CHINA Rev. 11/07

•Do not leave your tent set-up for weeks at a time, be aware that exposure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign substance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

MADE IN CHINA